Pojistková skříňka WeatherDeck® 12 V DC - šedá, 8 okruhů

The BLUE SEA WeatherDeck® 4308-BSS watertight fuse panel is designed to provide centralized electrical management for 8 circuits in exposed marine environments such as open cockpits and flybridges. It protects the boat's electronic equipment with fuses and provides clear monitoring of each circuit's status.

This fuse panel is designed to operate with a maximum voltage of 12V DC.

The WeatherDeck® 4308-BSS panel is an 8-position model, meaning it can manage up to 8 independent electrical circuits.

The panel uses ATO®/ATC® type fuses. Each position comes pre-installed with a 15A fuse.

Each circuit is equipped with bicolor LEDs that clearly indicate its state:

Red: The circuit is off. Green: The circuit is on. No color: The circuit's fuse is blown.

Yes, the backlighting of the labels is independent, allowing remote switching and dimming. It is compatible with Blue Sea Systems digital dimmers, such as the DeckHand Dimmers.

The panel is built with robust materials for the marine environment:

The cover is made of UV-resistant thermoplastic. The panel is made of flame-resistant UL-V0 thermoplastic. It incorporates reinforced polycarbonate and a UV-stabilized front plate, as well as watertight boots for the switches.

Panel dimensions are as follows:

Height: 195.58 mm (7.70 in)Width: 98.55 mm (3.88 in)Depth: 63.5 mm (2.50 in)

The WeatherDeck® 4308-BSS fuse panel weighs 0.7 kg.

The maximum cumulative current capacity for this 8-position panel (model 4308) is 100A.

Yes, the front panel is rated waterproof IP67 when properly installed with its supplied gasket. This means it is protected against immersion up to 1 meter for 30 minutes.

The panel can be mounted in any of the four different orientations, providing installation flexibility.

To ensure a watertight installation, the panel must be properly sealed to the mounting surface. The included sealing gasket must be in place and the panel securely screwed down. Additionally, the boots on the rocker switches must be tightly secured.

Yes, a cutting template is provided with the panel to facilitate preparation of the opening required for its installation.

Yes, a set of square-format labels (Square Format Label Set 4215) is included with the panel to clearly identify each circuit.

No, the switches on the panel are not flame-resistant. Therefore, the panel must NOT be installed in an explosive environment such as a gasoline engine compartment or a battery compartment.

The panel includes a special feature for navigation lights. To use it, connect to the 0.25" quick-connect tab labeled "NAV Diode" on the rear PCB of the panel. Follow these steps:

Connect the bi-color bow lights to switch #2.Install a 16 AWG jumper wire between the "NAV Diode" tab and the output terminal of switch #3.Connect the 360° anchor light to switch #3.This setup powers the 360° anchor light when the bi-color bow lights are on, while allowing the anchor light to be lit independently without powering the bow lights.

Yes, the independent backlighting of the labels is compatible with Blue Sea Systems digital dimmers, such as the DeckHand Dimmers, allowing remote dimming.

Yes, this panel is designed to be integrated into any standard 12V DC marine electrical system, providing a solution for circuit distribution and protection.

Blue Sea Systems supports its products for as long as you own them.