ECLIPSE CL30, osvětlení zdvořilostního osvětlení

The Garmin ECLIPSE CL30 courtesy light is a compact and versatile LED solution designed for supplementary and courtesy lighting aboard vessels. It is ideal for illuminating walkways, steps, helm stations or other architectural areas.

The electrical consumption of the ECLIPSE CL30 light is low, typically between 0.5 and 1W per light. The current draw is approximately 0.08A at 12V.

Yes, the ECLIPSE CL30 courtesy light is fully sealed with an IP67 or IP68 protection rating. It is suitable for damp environments, whether indoors or outdoors, but is not designed for permanent submersion in water.

The courtesy light ECLIPSE CL30 is available in monochrome versions (blue, white), bicolor (blue and white) and RGB.

Yes, the ECLIPSE CL30 courtesy light is fully sealed and can be installed indoors or outdoors, including in damp areas. However, it is not designed to be permanently submerged in water.

The light is designed for flush-mount installation on flat surfaces. It requires a cutout hole of approximately 22.5 mm (0.88 inches) to 23 mm (0.90 inches) in diameter and a maximum depth of 18 mm (0.70 inches). Installation is simplified by a 2-wire wiring system. It is recommended to use clear marine sealant between the lens and the mounting surface, as well as between the hex nut and the back of the mounting surface.

Before any installation, always ensure that the vessel's power source and battery are disconnected or isolated. It is also recommended that a qualified professional performs the electrical and mechanical installation.

Yes, a transparent marine sealant must be used between the lens and the mounting surface, as well as between the hex nut and the back of the mounting surface to ensure watertightness. Clean any excess sealant with a soft cloth, water, and soap, without using chemical cleaners.

The ECLIPSE CL30 courtesy light must be mounted on a flat, non-curved surface.

The light uses a simple 2-wire wiring (red and black). It is important to use a cable of appropriate gauge to ensure a voltage drop of less than 3% up to the last light in the chain.

The ECLIPSE CL30 light is designed to operate on 12V boats only and can function within a voltage range of 10 to 15V DC.

No, the ECLIPSE CL30 light is designed to operate only with 12V DC systems. It must not be connected to AC voltage or voltages outside the 10–15V DC range.

No, the ECLIPSE CL30 light is designed to be used with a simple on/off switch or with the ECLIPSE Control Center. It must not be connected to other third-party lighting control products or dimmers.

RGB versions of the ECLIPSE CL30 light require an ECLIPSE Control Center for control. There is no switch control option for RGB versions.

The monochrome and bicolor versions of the ECLIPSE CL30 light can be controlled via a simple on/off switch. For the monochrome versions, the switch allows dimming the light intensity. For the bicolor versions, it allows changing the color.

No, it is not recommended to add monochrome and bicolor lights to the same zone output of the ECLIPSE Control Center. Use a separate zone output for each type.

The ECLIPSE CL30 lighting system is warranted by LUMISHORE Ltd against manufacturing defects for a period of three years from the original purchase date.

The warranty may be voided in case of misuse, abuse, incorrect installation, negligence, improper shipping, damage caused by disasters (fire, flood, storm, lightning), installation by unqualified personnel, unauthorized repair or modification, or failure to comply with all installation, maintenance, and usage instructions provided in the document.