ECLIPSE DL55, stropní svítidlo bílé, černá povrchová úprava

The Garmin ECLIPSE DL55 downlight is designed for general lighting aboard boats, providing a versatile solution for indoor and outdoor applications.

This specific ECLIPSE DL55 downlight model is equipped with white LEDs.

The ECLIPSE DL55 downlight has a typical power consumption of approximately 4 watts per fixture. Its current draw is 0.33 amperes at 12 volts DC.

Yes, the ECLIPSE DL55 downlight is fully sealed and can be installed indoors as well as outdoors. It is suitable for wet areas but is not designed to be permanently submerged in water.

The ECLIPSE DL55 downlight features a durable aluminum body and a glass face, ensuring robustness in a marine environment.

The Garmin ECLIPSE DL55 downlight has an IP67 rating, meaning it is protected against dust and temporary immersion in water.

No, although it is protected against temporary immersion (IP67), the ECLIPSE DL55 downlight is not designed to be permanently submerged in water.

Yes, the rear of the ECLIPSE DL55 downlight can become hot to the touch. The mounting surface must be suitable for this type of luminaire installation.

The required cut-out diameter for installing the ECLIPSE DL55 downlight is 50.8 mm (2.0 inches).

The ECLIPSE DL55 downlight has a front bezel diameter of 64.0 mm (2.519 in), a depth of 21.2 mm (0.834 in), and a profile of 3.5 mm (0.137 in).

For indoor installations, the downlight is secured using the supplied spring clips. Gently pull the clips backward, insert the fixture into the cutout hole, and release the clips to position it.

For outdoor installations or in damp areas, it is recommended to secure the light fixture with suitable marine adhesive/sealant. Remove the spring clips and the black gasket, apply a small amount of adhesive around the glass lens, then push and slightly rotate the light fixture to spread the adhesive evenly.

Yes, it is imperative to always ensure that the boat's power source and battery are disconnected or isolated before attempting any installation.

Yes, it is strongly recommended that a qualified professional performs the electrical and mechanical installation of the ECLIPSE DL55 downlight.

Yes, the downlight must be mounted on a flat surface, not a curved one. As the rear of the fixture can get hot, the mounting surface must be suitable for this type of lighting.

It is important to use a properly sized cable to ensure a voltage drop of less than 3% at the last fixture in the circuit.

The ECLIPSE DL55 downlight is designed to operate exclusively on 12V DC systems, with an operating range of 10 to 15V DC.

No, the ECLIPSE DL55 downlight must not be connected to voltages outside the 10–15V DC range, nor directly to an AC voltage.

No, the ECLIPSE DL55 downlight is designed to be used with a simple on/off switch or with the ECLIPSE Command Center. It must not be connected to other third-party lighting control products or dimmers.

For single-color lights (like this white model), toggle the switch to adjust the light intensity, then toggle it again to pause. To reset the light to full power, turn off the switch for 2 seconds.