ECLIPSE, zapuštěný reflektor širokého svazku 4 palce

The GARMIN ECLIPSE Flood Light 4" is equipped with 3 white 10 W LEDs, providing a luminous intensity of 1,500 lumens. It emits white light with a color temperature of 5,500 K and an oval beam of 70°-90°.

Yes, this spotlight is designed for the marine environment and has IP68 waterproof certification. This means it is fully protected against dust and can withstand prolonged immersion in water.

The GARMIN ECLIPSE Flood Light 4" operates on a voltage range of 10 to 31 VDC (direct current).

The maximum power consumption of the spotlight is 1.7 A at 12 V and 0.9 A at 24 V. Its average power is 22 W.

Yes, the spotlight is dimmable as standard, offering flexibility to adjust light intensity according to your needs.

For a flush-mounted installation, follow these steps:

Select a flat and durable location, free of obstructions behind the mounting area. Use the provided template (reference 45-0216) to drill a small pilot hole, then 10 mm holes in each corner before cutting the sides with a saw. It is recommended to cut slightly smaller than needed and adjust with a file if necessary. Mount the projector in place using high-quality marine sealant (e.g., 3M 4200). Secure the projector with appropriate screws and tighten to a torque not exceeding 5 Nm. Immediately clean any excess sealant with a cloth and soapy water (do not use chemicals that could damage the projector).

The recommended cut-out dimension for flush mounting is 113 mm, following the provided template (reference 45-0216).

For flush mounting, it is recommended to use a high-quality marine sealant, such as 3M 4200.

During flush mounting, the screw tightening torque must not exceed 5 Nm.

The spotlight can be controlled in several ways:

Via a simple on/off switch.Through an MFD (multifunction display) via an LUX light control module and an EOS-LUX command center.With an ECLIPSE command center to manage one or more spotlights.

The spotlight is built with a powder-coated aluminum body and a frosted lens, ensuring its robustness and durability in the marine environment.

Yes, the cable entry must be made watertight. Using a cable gland is recommended to ensure watertightness.

For simple on/off control, connect the red wire of the projector to a 10-31V power source and the black wire to ground (GND). The two yellow wires must remain unconnected.

With a simple switch (rocker type), the operation is as follows:

Turn the switch on to power the light at full brightness.Switch the switch once to start the dimming cycle.Switch the switch again to pause the dimming cycle.Turn the switch off for 5 seconds to restart at full brightness.

No, the ECLIPSE control head installation is only suitable for 12V boats.

Yes, the ECLIPSE control unit is designed to manage more than one spotlight, provided the boat's electrical system is 12V.

Yes, it is possible to control up to 16 floodlights via an MFD using an LUX lighting control module and an EOS-LUX command center.

During an installation with a mount, a 6 mm (0.236 inches) hole is required for cable passage. The cable must be in a fixed position, with no movement or rotation.

When simply connecting with an on/off switch, the two yellow wires of the underwater light are marked as "No connect" (not connected) in the wiring diagram.