ECLIPSE SL100, LED pás modré a bílé barvy, 1 m

The Garmin ECLIPSE SL100 light bar has a length of one meter (1m).

This LED strip combines blue and white LEDs. It integrates 60 blue LEDs and 60 white LEDs (5000K) per meter.

Yes, the Garmin ECLIPSE SL100 LED strip light is specifically designed for marine accent and ambient lighting.

Yes, the LED light strip is fully encapsulated and carries an IP68 rating. This means it is protected against dust and temporary immersion. It is not, however, designed for permanent submersion.

Yes, the LED strip is made from UV-resistant materials and can be installed indoors or outdoors. However, it is not recommended to install it in areas with intense direct sunlight.

Typical power consumption is about 5 watts per meter for each channel (blue or white), i.e. a current of about 0.41A at 12V per channel.

The light strip can be bent to a minimum radius of 50mm, but only along the vertical axis. It is important not to twist or bend it along the horizontal axis.

Yes, it is essential to always ensure that the boat's power source and battery are disconnected or isolated before proceeding with installation.

Yes, the LED strip can be cut. Locate the cutting point closest to the required length, cut only at the marked cutting points, and use a single cutting motion at the center of the cut marks.

To seal the cut end, remove 20mm of the adhesive backing, lightly scrape the adhesive 10mm from the end to expose the silicone. Fill the end cap halfway with the supplied silicone adhesive, then fit the cap. Allow to cure for 24 hours before handling.

The light strip comes with a 3M adhesive backing. Clean the mounting surface thoroughly with IPA, then remove the adhesive film and press firmly along the edges of the strip. For outdoor installations, wet areas, or tight bends, mechanical fasteners (mounting clips) should be used in addition to the adhesive, every 250 to 300mm.

A qualified professional should perform the electrical and mechanical installation to ensure proper and secure setup.

No, it is important not to wire the blue and white channels so they light up simultaneously. They must be controlled separately.

Yes, the strip must not be allowed to droop or twist during installation. Unroll it carefully from the reel. Do not apply pressure on the LED area; press only on the edges of the strip. Do not pull, stretch, twist, or bend the strip on the horizontal axis. For lengths over one meter, it is recommended to install with two people.

After securing the LED strip with 3M adhesive, it is recommended to let the adhesive cure for 24 hours before powering on the strip. Similarly, if you have cut and sealed an end, the silicone must cure for 24 hours before any handling.

This LED strip is designed to operate only on boats equipped with a 12V electrical system. It can function within a voltage range of 10 to 15V DC.

No, you must not connect this LED strip to an AC voltage (alternating current) or to any voltage outside the 10–15V DC range.

Yes, this two-tone LED strip (blue and white) can be used with an ECLIPSE Command Center. For full control, consult the Command Center installation manual.

Yes, the bicolor LED strip can be controlled with a switch. The switch connects to the negative wires of the LED strip.

No, it is recommended not to add single-color, bicolor, and RGB lights to the same zone output of a Command Center. Use a separate zone output for each type.