ECLIPSE SL100, LED pás modré bílé, délka 5 m

The Garmin ECLIPSE SL100 LED strip has a length of 5 meters, providing flexibility for various lighting applications on your vessel.

This specific model, the ECLIPSE SL100, features dual-color LEDs providing both blue and white lighting. This allows for distinct lighting ambiances aboard.

Yes, the ECLIPSE SL100 LED strip is specifically designed for marine environments. It is made from UV-resistant materials and features a fully encapsulated and overmolded construction, making it suitable for the demanding conditions of vessels.

The ECLIPSE SL100 LED strip has an IP68 water and dust resistance rating. This means it is protected against temporary immersion in water and dust, making it suitable for installation both indoors and outdoors, including damp areas of the boat. However, it is not designed for permanent immersion.

Yes, the ECLIPSE SL100 LED strip is made from UV-resistant materials. However, it is recommended not to install it in areas exposed to direct strong sunlight to optimize its lifespan.

Each channel (blue and white) of the ECLIPSE SL100 light strip has a typical power consumption of about 5 watts per meter.

Typical current draw for each channel (blue or white) of the ECLIPSE SL100 strip light is 0.41 A at 12 V.

The ECLIPSE SL100 strip light is ideal for decorative and indirect lighting. It can be installed under side decks, cabin furniture, behind ceiling panels, or in other interior or exterior areas of the vessel, including wet areas. It is not designed for permanent submersion.

Yes, the LED strip can be cut to the desired length. It is important to locate the cutting points marked on the strip and use a pair of scissors to make a clean cut in the center of the cutting pads.

After cutting the end cap, it is essential to seal the end to maintain waterproofing. Remove 20mm of the adhesive backing, then lightly scrape the adhesive 10mm from the end to expose the silicone. Fill the end cap (provided) halfway with silicone adhesive (also provided), then attach the cap. Allow to cure for 24 hours before handling.

The ECLIPSE SL100 LED strip has a minimum bend radius of 50 mm (1.968 inches) on the vertical axis. It is critical to respect this limit to avoid damaging the product.

Yes, it is important not to bend the light strip on the horizontal axis or twist it. Bending is only allowed on the vertical axis, with a minimum radius of 50 mm.

The LED strip comes with a 3M adhesive backing for easy installation. For outdoor installations in wet areas or with tight bend radii, it is strongly recommended to use mechanical mounting clips in addition to the adhesive.

Yes, during installation, unroll the strip carefully from its reel and do not let it drop or twist. Do not apply pressure to the LED area, only on the edges of the strip. For lengths over 1 meter, it is recommended to use two people for installation.

After securing the light strip with the adhesive, it is recommended to let the adhesive set for 24 hours before turning on the strip. If you have sealed a cut end, the silicone must also cure for 24 hours.

The ECLIPSE SL100 LED light bar is designed to operate exclusively with 12V boat systems. It can function within a voltage range of 10 to 15V DC.

No, the ECLIPSE SL100 LED strip is designed to operate only with 12V DC systems. It must not be connected to voltages outside the 10–15V DC range, nor directly to AC (alternating current) power.

No, it is important not to wire the blue and white channels together so they light up at the same time. The strip is designed for a two-color lighting system where the colors are selected separately.

For simple control, the two-tone strip can be connected to a three-position switch (On/Off/On) to select blue or white lighting. For advanced control, it can be integrated into a Garmin ECLIPSE control head by following its installation manual.