LUX SL180, LED pás, CRGBW, 4500 mm

The Garmin LUX SL180 light strip has a fixed length of 4500 mm.

The LED strip provides a full CRGBW spectrum, meaning it can produce cool, red, green, blue and warm colors. The white temperature is also adjustable, ranging from 2700K to 6500K.

Yes, it is specifically designed for marine lighting. It is factory-sealed to ensure IP68 waterproofing, making it suitable for indoor and outdoor installations, including damp areas on a boat. Its design is also UV-resistant and tested against salt spray for enhanced durability in this environment.

Yes, the LUX SL180 LED strip is fully sealed and can be installed indoors or outdoors. It is rated IP68, meaning it is protected against temporary immersion and dust. It is UV-resistant and tested for salt spray, ensuring durability in a marine environment.

The light strip has a low-profile design with a width of 14.5 mm, making it easy to integrate discreetly.

The power consumption of the LED strip is 5 watts per meter. For a total length of 4500 mm (4.5 meters), the total consumption is 22.5 watts.

No, it is imperative not to cut the light strip. It is supplied in ready-to-use lengths and factory-sealed to meet IP68 standards. Cutting it would compromise its integrity and IP68 classification, and void the warranty.

The Garmin LUX SL180 light strip integrates 180 LEDs per meter.

The light strip can be installed in two ways:

Using the integrated 3M adhesive.By reinforcing it with mechanical mounting clips for increased security, especially outdoors or in vibration-prone areas. These clips should be spaced 25 to 30 cm apart and/or on either side of a curve.

Yes, the LED strip has a minimum bending radius of 50 mm on the vertical axis. However, it must not be bent on the horizontal axis or twisted.

Yes, always ensure the vessel's power source and battery are disconnected or isolated before proceeding with installation.

Yes, a qualified professional should perform the electrical and mechanical installation of the LED strip.

During handling, it is important to:

Do not let the light strip fall or twist. Unroll it carefully from the spool. Do not apply pressure on the LEDs, only on the edges of the strip. Do not pull, stretch, twist, or bend the strip along the horizontal axis. Always use two people to install lengths over one meter. Always lay the strip flat in a straight line, without allowing it to bend, twist, or bunch up.

The 3M adhesive must cure for 24 hours before powering on the LED strip.

The LED strip is made from UV-resistant material, but it must not be installed in areas exposed to direct sunlight.

The LUX SL180 light strip must be used together with the Lumishore LUX strip light driver modules (Lumishore LUX Strip Light Driver Module).

No, the LUX SL180 light strip is designed to be used only with Lumishore LUX light strip controller modules. Connecting to other third-party products or controllers will void the warranty.

The required input voltage range is 23 to 25V. It must be used exclusively with Lumishore LED light strip control modules.

Lumishore Ltd guarantees its lighting systems, lights, and associated accessories against any manufacturing defects for a period of three years from the original purchase date.

The warranty will be void in the following cases:

Misuse, abuse, or incorrect installation. Negligence, improper shipping, or damage caused by disasters (fire, flood, storm, lightning). Installation by unqualified personnel. Unauthorized repair or modification. Unapproved installations or non-compliance with installation, maintenance, and usage instructions provided in the documentation. Use with third-party controllers other than the Lumishore LUX LED strip controller module.