LUX SL180, pásové světlo, CRGBW, 1300 mm

The Garmin LUX SL180 light bar has a length of 1300 mm.

This LED strip provides CRGBW full-spectrum lighting, including cool white, red, green, blue, and warm white.

Yes, the LUX SL180 LED strip is designed for indoor and outdoor installation above the waterline. It is made from UV-resistant materials and has been tested for salt spray resistance to withstand the marine environment.

No, the LUX SL180 light strip is not designed to be cut. The technical documentation explicitly states not to cut the light strip, as it is supplied in pre-fabricated and factory-sealed lengths to meet IP68 standards.

The LUX SL180 LED strip has an IP68 protection rating. This means it is resistant to dust and water, making it suitable for damp areas, but it is not designed for permanent submersion.

The LUX SL180 light strip operates within an input voltage range of 23 to 25V.

The LUX SL180 light strip requires a Lumishore LUX Strip Light Driver module. It must not be connected to any other third-party lighting control products or drivers.

The average power consumption of the LUX SL180 light strip is 5 W/m.

The light strip has a minimum bending radius of 50 mm only on the vertical axis. Do not bend it on the horizontal axis or twist it.

The light strip can be installed using its integrated 3M adhesive strip. It is recommended to thoroughly clean the mounting surface with IPA, then remove the adhesive's protective film and firmly press the light strip into place by pressing only on the edges. Allow the adhesive to set for 24 hours before turning on the light strip.

For outdoor installations in wet areas or with tight bends, it is recommended to use mechanical fasteners in addition to the adhesive layer. These fasteners should be spaced 25 to 30 cm apart or placed on each side of a bend.

Although the LED strip is made from UV-resistant materials, it must not be installed in areas exposed to direct strong sunlight.

The LUX SL180 features a density of 180 CRGBW LEDs per meter.

No, although the LED strip is sealed and can be installed in wet areas, it is not designed to be permanently submerged in water.

Lumishore lighting systems, including lights and associated accessories, are warranted against manufacturing defects for a period of three years from the original purchase date.

It is always recommended that a qualified professional performs the electrical and mechanical installation of the light strip.

The tunable white feature allows adjusting the color temperature of white light from 2700K (warm white) to 6500K (cool white) within a single luminaire, providing versatility to create different lighting ambiences.

Do not let the strip fall or twist during installation; carefully unroll it from the reel. Do not apply pressure on the strip at the LED level; press only on the edge of the strip. Do not pull, stretch, twist, or bend the strip on the horizontal axis. For lengths over 1 meter, always use two people for installation. Always lay the strip flat in a straight line.

Yes, using the LUX strip light with third-party autopilots will void the warranty. It is designed to work only with the Lumishore LUX Strip Light Driver module.

Yes, Lumishore can supply stainless steel mounting clips as an option for narrow mounting channels. These are secured using a countersunk screw.