TIX402, podvodní vestavná průchozí kamera

The TIX402 underwater camera delivers Full HD 1080p resolution. It also includes features such as wide dynamic range (WDR) and 3D digital noise reduction (3D-DNR) for optimal image quality.

The TIX402 camera is equipped with a fixed 3.6 mm focal length lens providing a 67-degree field of view.

The TIX402 camera housing is made of marine-grade bronze, ensuring durability and resistance to the marine environment. The lens is made of hardened borosilicate glass BK7.

Yes, the TIX402 camera is designed to operate in low-light conditions. It features an automatic low-light mode and requires a minimum illumination of only 0.01 Lux.

Main dimensions of the TIX402 camera are:

Housing face diameter: 88 mm (3.47 in)
Housing profile height (protrusion): 8 mm (0.32 in)
Shaft (rod) length: 136 mm (5.35 in)

The TIX402 underwater camera weighs approximately 1.2 kg (2.6 lbs).

The TIX402 camera provides two types of video output:

An HD-SDI output via a BNC connector. A Composite (SD) output via a BNC connector. These options allow flexibility in connecting to different display systems.

For installing the TIX402 camera, a 57 mm (2-1/4 inches) diameter hole must be drilled in the hull. Note that this size may vary if insulation sleeves are used.

The TIX402 camera can be installed on GRP (glass-reinforced plastic or fiberglass) and wooden hulls. For installations on metal hulls, insulating sleeves are available and must be used.

Ideally, the TIX402 camera should be installed between 150 and 250 mm (6 to 10 inches) below the water surface. While this depth is not critical, it is recommended for optimal performance.

It is recommended to use an approved adhesive such as 3M 4200 Marine or a similar product. It must be applied generously and continuously around the circumference of the sealing groove and on the through-hull fitting stem.

Yes, it is essential to ensure there is a clearance of more than 17.8 cm (7 inches) inside the hull. This space is required to be able to remove the camera module if needed.

Yes, all Lumishore cameras, including the TIX402, must be connected to the vessel’s DC bonding system to provide protection against electrolytic/galvanic corrosion. A grounding connection is provided on the housing.

Yes, the HD camera module TIX402 is supplied with an external fuse holder and two fuses. The correct fuse for a 12-volt power supply is a 1 A fuse. Each camera must be fused individually.

Yes, the TIX402 is an "interchangeable" camera, meaning the camera module can be removed from inside the hull. However, removal must only be done after consulting Lumishore and only in case of camera failure or module upgrade.

Yes, the camera is sensitive to temperature. It must not be exposed to temperatures above 65°C (150°F). For example, avoid installing it near hot engine components or where exhaust emissions could be sprayed onto the camera.

The TIX402 camera operates exclusively on 12 Volts DC. Its power consumption is 3W, with a maximum current draw of 0.25 A per module.

The TIX402 camera has HD-SDI and Composite (SD) video outputs. It can be connected directly to a display compatible with these inputs. For HDMI displays, an HD-SDI to HDMI converter may be required.

The TIX402 underwater camera is covered by a 2-year warranty. It is important to note that improper grounding of the cameras or unauthorized removal of the internal module will void the Lumishore warranty.