Adaptér kabel (8 na 25 pinů) pro sondu CP370 na Axiom RV

This A80489 adapter cable connects an existing marine transducer with an 8-pin connector (originally designed for a Raymarine CP370 sounder module) to a Raymarine Axiom RV series multifunction display with a 25-pin sounder port.

Yes, that is precisely the function of this adapter. It was designed to allow users to keep their CP370-compatible transducer (8-pin connector) when upgrading to an Axiom RV display (25-pin port), thus avoiding the need to replace the transducer.

No. This adapter allows your traditional transducer to display standard 2D sonar data on your Axiom RV display. It cannot add features that the transducer does not already have. To use DownVision, SideVision, or RealVision 3D technologies, you must use a transducer specifically designed for these functions.

No, installation is very simple and 'plug-and-play'. Simply connect the cable from your transducer (8-pin connector) to the corresponding end of the adapter, then screw the other end (25-pin connector) into the 'RealVision 3D' port located at the rear of your Axiom RV display.

In general, the Axiom RV display automatically detects the type of connected transducer. However, it is recommended to check in the sounder settings that the correct transducer model is selected from the list to ensure optimal performance.

Yes, if your original transducer (CP370-compatible) is equipped with a temperature sensor, this adapter will transmit temperature data to your Axiom RV display without any issues.

This adapter is specifically designed for the Raymarine ecosystem. It is intended to connect Raymarine transducers (or Airmar-compatible transducers for Raymarine) with an 8-pin connector to Raymarine Axiom RV displays. Use with other brands is not guaranteed and may damage your equipment.

Yes, both connectors are equipped with a threaded locking ring that ensures a secure and watertight connection, designed to withstand marine environments and vibrations.

The main advantage is economic and practical. It lets you keep your existing depth sounder, which is often expensive and complex to install (especially through-hull models), while benefiting from the performance and interface of a latest-generation multifunction display.

This adapter will work with traditional transducers (non-CHIRP or single-frequency CHIRP) that were compatible with the CP370 module. It will transmit the transducer signal to the Axiom RV, which can interpret it.

At the rear of your Axiom RV display, the fishfinder port is clearly marked. It is the largest round connector, with 25 pins, often labeled 'TRANSDUCER' or 'RealVision 3D'.

No. If you purchase a new Raymarine RealVision 3D sounder, it will come with the correct 25-pin connector for direct connection to your Axiom RV. This A80489 adapter cable is only needed if you want to reuse an old 8-pin sounder.