Snímač sonaru zasunovací

The unit must be mounted vertically, with the cables exiting from the bottom. It is important to note that the mounting template must be reversed compared to the transducer itself.

You will need to drill three 2.5 mm holes to secure the T912. These holes are marked 'B' on the provided mounting template.

The T912 is secured using the self-tapping screws provided with the device.

Yes, it is very important not to overtighten the screws when mounting the T912. Overtightening could damage the device’s housing and compromise its integrity.

Transducer cables must be connected following the color code indicated on the unit. It is also essential to sleeve the ground braids to prevent short circuits.

For a Triducer, the ground braid must be connected to the depth connector and not to the speed connector. This is crucial to avoid short circuits and ensure proper operation.

If your speed sensor does not have a temperature sensor, you must connect the brown and white wires of the speed connector. This ensures proper data interpretation by the transducer.

Yes, it is recommended to apply silicone grease to terminal contacts. This optimizes conductivity and provides additional protection to electrical connections.

It is recommended to secure and support cables near the transducer. This helps reduce strain on connections and keeps the installation clean and secure.

Yes, the T912 can be used with existing or older transducers. However, it is recommended to carefully check the connections and wiring, especially for speed transducers without a temperature sensor, to ensure proper connection between the brown and white terminals.

The T912 transmits depth, speed, and temperature data collected from connected transducers. This information is then used by Raymarine instrument systems for display and analysis.