BEP CC KEY SW & 4 X CB MOD SGL ENG

The BEP CC KEY SW & 4 X CB MOD SGL ENG (80-700-0050-00) is a battery management module designed for single-engine marine electrical installations. It includes a key switch and four circuit breakers. This module is part of BEP's Contour Connect and Battery Control Center (BCC) modular panel systems, enabling efficient remote power management.

This module shows the following nominal currents:

Continuous current: 275 amperes DCIntermittent current: 455 amperes DCStarting current: 1250 amperes DC

The maximum voltage supported by this battery management module is 32 Volts DC.

Yes, this module is ignition-protected. It complies with the following standards:

UL1107 (for ignition protection)CEIP66ABYC

Yes, this module is specifically built to withstand demanding marine and motorhome environments, thanks to its robust design and compliance with IP66 standards.

The electrical consumption of the switch, when the system is in the 'off' position, is 15 mA.

This module allows remote switching of battery banks. It has two operating modes: automatic and manual. In automatic mode, the module is controlled by a remote switch (for example, a key switch at the helm). The manual mode allows overriding the automatic operation at any time by pressing the control button directly on the module.

The LEDs on the switch and the key switch (if used) indicate the switch status:

LED off: The switch is off.\nLED on: The switch is on.\nLED flashing: The switch is transitioning between 'on' and 'off' in automatic mode.\nLED fast flashing (0.1 sec on & 0.1 sec off): Voltage is outside specifications (below 8 Volts or above 30 Volts).

The motorized switch is supplied with a generic battery label. A range of the most commonly used labels (reference 713) can be ordered separately if required.

This module is designed to optimize cable routing, allowing shorter cable lengths to starters and other high-current applications such as bow thrusters and inverters. This helps minimize voltage drop and the use of heavy-duty cables.

The module can be installed in two ways: flush-mounted or surface-mounted. The installation manual includes a cutting template for flush-mount installation.

The module uses two 10 mm (3/8") studs for the connections. These studs are made of tinned copper and are supplied with nuts.

The maximum recommended cable size is 50 mm². If a cable larger than 50 mm² is used, it must be stress-relieved with an absolute maximum of 00 AWG or 70 mm².

To remove the knob: Turn the knob to the 'off' position. The knob is always locked on the switch. Press and continue turning counterclockwise until it stops. The knob can then be removed.To replace the knob: Place the knob in the switch housing. Press and turn clockwise by 45° to the 'off' position.

No, as this switch is designed for immersion to 1.8 meters (6 feet), no solvent or sealing product should be used. A petroleum-based grease can be applied to the stud-terminal junction.

The rear and side panels of the module are removable. This allows easy access for cable routing and installation of connections.

Yes, two mounting screws are supplied with the module to allow it to be fixed to other products in the BEP 700 series.

Yes, this module is part of BEP’s Contour Connect and Battery Control Center (BCC) modular panel systems, ensuring good integration with these platforms.

The automatic operating voltage range for this module is 8 to 30 Volts DC. If the voltage is outside this range, the switch LED will flash rapidly.

For remote control, a key switch (e.g., the BEP 722-KS) or any standard on/off switch can be used to activate the motorized switch from the helm.