Lewmar VX2 windlass with capstan – 12 V 700 W, 10 mm ISO chain

The Lewmar VX2 windlass is equipped with a 700 W motor.

Yes, this Lewmar VX2 windlass is designed to operate with a 12 V power supply.

Yes, this Lewmar VX2 windlass model comes with an integrated warping end, allowing you to handle ropes independently of the anchor chain.

The gearbox of this windlass has IP67 protection, providing high resistance to temporary immersion and dust.

This windlass belongs to the VX2 range from Lewmar.

This windlass is specifically designed for a 10 mm ISO chain. It is important to use the correct type and size of chain to ensure optimal operation of the wildcat.

This windlass is compatible with a 16 mm diameter rope.

No, this windlass is specifically designed for a 10 mm ISO 4565 chain. Using a 10 mm DIN766 chain would require a different sprocket, as the link profiles are not identical.

Lewmar wildcats are ideally suited for factory-made Lewmar rope/chain combinations. For ropes from other manufacturers, which may vary in stretch and diameter consistency, testing may be required to determine the optimal size. It is essential that the ropes used are windlass-grade, medium-strand nylon.

The gypsy of this windlass is compatible with 3-strand and 8-strand nylon ropes, with a diameter between 12 mm (1/2”) and 16 mm (5/8”).

Lewmar recommends a minimum deck thickness of 40 mm (1 1/2”). For thicker decks, a longer shaft may be required (non-standard), and for thinner decks, a deck spacer is available.

Yes, there must be sufficient vertical drop for the chain or rope during retrieval. A minimum of 300 mm (12”) is required to prevent jams. The motor/reduction gearbox must not be positioned directly under the chain/rope drop zone.

The windlass must be positioned so that the anchor rode from the hawsepipe feeds horizontally upward to the top of the gypsy and along its central axis, with a tolerance of ±5°. It is important to plan the location considering the hawsepipe, chain locker, and the rotation of the manual control handle.

Yes, thin decks or those constructed with foam or balsa core will require reinforcement to distribute the high loads applied to the deck when using the windlass. If in doubt about the deck construction, consult a qualified marine engineer.

A suitable marine sealant should be applied to the edges of freshly cut holes to prevent water absorption by the deck. If a silicone or rubber-type sealant is used, it is advisable to let it cure before the final tightening of mounting bolts. Do not use permanent adhesive/sealant such as 5200.

The mounting studs of the VX2/3 windlass must be tightened to 21 Nm. The M8 nuts under the deck must also be tightened to 21 Nm using Loctite® thread locker.

No, a windlass must never be used as a mooring cleat. The anchor rode MUST be secured to a mooring cleat, chain stopper, or another designated anchoring point. Using the windlass to secure the rode would damage it and could compromise safety.

To ensure optimal performance and avoid voiding your warranty, it is recommended to use only Lewmar original parts and accessories.

Yes, the windlass is supplied with a complete installation, operation, and owner’s maintenance manual providing all necessary instructions.