AC Circuit Breaker Gen2 - Single Pole 230 VAC, 35 A, Medium Trip Delay

The Raymarine Gen2 single-pole AC circuit breaker is designed to protect alternating current (AC) electrical circuits on board vessels, tripping in case of overload or short circuit.

This circuit breaker is a single-pole model, designed to operate at 230 VAC with a rated current of 35 A.

An average trip time indicates that the circuit breaker reacts to an overload or short circuit within a moderate time frame, which is suitable for a wide range of marine applications to prevent nuisance tripping while ensuring effective protection.

Yes, this circuit breaker allows remote activation and deactivation when integrated into the OctoPlex G2-Series power distribution system.

Yes, thanks to its integration into the OctoPlex G2-Series system, it is possible to remotely monitor the circuit status (enabled/disabled, tripped).

The redundant architecture of the OctoPlex G2-Series system, based on a CAN bus NMEA 2000 network, eliminates single points of failure, thereby increasing the reliability and safety of the entire vessel’s electrical system, including circuit breakers.

Yes, the OctoPlex system circuit breakers, including this model, are designed to be "field-replaceable", which simplifies maintenance.

This circuit breaker is specifically designed to protect AC (alternating current) loads on board a vessel, such as household appliances, battery chargers, or other AC equipment.

A single-pole circuit breaker is designed to interrupt only one phase of an alternating current circuit. It protects a single live conductor.

The OctoPlex G2-Series system, of which this circuit breaker is part, is CE certified, IEC60533, IEC60945, NMEA 2000 Approved (Certified, Category B) and Lloyd’s Type Approved.

This circuit breaker is a key component of Maretron’s OctoPlex G2-Series power distribution system, designed for centralized management and remote control of the vessel’s electrical equipment.

Yes, it is specifically designed to integrate and operate with OctoPlex G2-Series power distribution systems.

Yes, due to its integration with the OctoPlex G2-Series system, which uses a CAN bus NMEA 2000 network, this circuit breaker is compatible and communicates via this protocol.

No, this circuit breaker is specifically designed for 230 VAC systems. It must not be used with nominal voltages for which it is not rated.

Yes, the OctoPlex G2-Series system allows monitoring and control of other common NMEA 2000 devices aboard the vessel, such as compasses, GPS units, or tank level adapters.

Integrating this circuit breaker into the NMEA 2000 network via the OctoPlex G2-Series system significantly reduces the complexity of traditional wiring, thereby simplifying the vessel's overall electrical installation.

Yes, the OctoPlex G2-Series system architecture enables flexible management of electrical panels, allowing them to be placed in remote locations without requiring large traditional electrical panels.

Yes, OctoPlex products, including this circuit breaker, are not ignition-protected devices and must not be installed in areas with combustible vapors.

Yes, once physically installed, this circuit breaker requires configuration via the OctoPlex G2-Series system to enable remote control, circuit status monitoring, and customization of trip profiles.

Yes, this circuit breaker is designed for European 230 V AC applications. The OctoPlex G2-Series system can be used in 110V, 220V, three-phase, and 240V European applications for its monitoring units, but this specific circuit breaker is for 230 V AC.