Deckhand feszültségszabályzó – 12 V DC 6 A

The Deckhand 7506-BSS dimmer is designed to digitally control the brightness of unregulated LED lights, incandescent lights, and halogen lights.

This variable pitch drive operates on a nominal voltage of 12 V DC.

The Deckhand 7506-BSS drive can operate within a voltage range from 9 V to 16 V DC.

The maximum output current capacity of the Deckhand 7506-BSS autopilot drive is 6 A.

The 'Bulb Saver' function is designed to prevent excessive aging of bulbs during the boat's electrical system charging phases.

Yes, the Deckhand 7506-BSS autopilot drive has memory for the last brightness setting used.

The drive is designed to operate within a wide temperature range, from -40 °C to 85 °C.

The maximum parasitic current of the Deckhand 7506-BSS drive is less than 2 mA.

The inverter uses continuous pulse-width modulation (PWM) control, allowing adjustment from 0 to 100% of the input voltage.

Yes, the autopilot drive is supplied with a momentary switch (ON)-OFF-(ON).

The dimensions of the Deckhand 7506-BSS autopilot drive are:

Width: 3.25 inches (82.55 mm)Height: 3.5 inches (88.9 mm)

Yes, the Deckhand 7506-BSS variable frequency drive is CE marked and compliant with ISO 8846 and SAE J1171 ignition protection requirements.

No, this dimmer is specifically designed to control the intensity of unregulated LEDs. It may not work properly or could damage regulated LEDs.

No, the 7506-BSS model is designed for 12 V DC systems. For 24 V DC systems, other models in the Deckhand range are available, such as PN 7504 or 7509.

The dimmer is specifically designed for unregulated LED, incandescent, and halogen lighting. Use with other types of bulbs is not guaranteed and may not function correctly.

The illuminated output function keeps the lights on for an adjustable duration after the dimmer is turned off. Here's how to set it:

1-minute delay: Hold the switch in the high (illuminated) position for 2 seconds. The lights will flash. Release the switch after the first flash. The lights will stay on for 1 minute.2- to 5-minute delay: Hold the switch in the high (illuminated) position for 1 to 4 seconds after the first flash. Release the switch after 2 to 5 flashes. The lights will stay on for 1 minute per flash, up to a maximum of 5 minutes.

Yes, the Deckhand 7506-BSS drive has offset mounting feet that allow multiple drives to be installed very close to each other.

Yes, the Deckhand 7506-BSS variable speed drive is designed to support multiple switch locations, providing installation flexibility.

To set the delay for the illuminated output function:

For a 1-minute delay: Hold the switch in the high (illuminated) position for 2 seconds until the lights flash once. Release the switch.

For delays of 2 to 5 minutes: Hold the switch in the high (illuminated) position for 1 to 4 seconds after the first flash, then release the switch after the number of flashes corresponding to the desired minutes (e.g., 3 flashes for 3 minutes).

The main connections of the Deckhand dimmer are as follows:

+12V DC (red): Positive power supply. Ground (black): Ground. Lamp (blue): Connection to lighting. Up Input (white): Input to increase brightness. Down Input (gray): Input to decrease brightness. An (ON)-OFF-(ON) switch is included for brightness control.