Horizontalus dvigubasis praėjimo lankas kabeliams Ø 5 ir 6 mm – pilko kompozito

The Scanstrut DS-HD6 deck gland is designed to provide professional watertight sealing when routing two cables through a boat's deck or bulkhead. It protects cables and the boat's interior from water and marine elements.

The Scanstrut DS-HD6 deck gland is made of gray composite, a material selected for its robustness and resistance to marine environments.

Yes, the Scanstrut DS-HD6 deck gland is UV-resistant and built for harsh marine environments, ensuring reliable durability and performance at sea.

The Scanstrut DS-HD6 deck hatch is gray in color.

This deck gland is a double model, meaning it can accommodate two cables simultaneously.

Yes, the kit includes a total of six plugs: two blank plugs, two 5 mm plugs, and two 6 mm plugs, allowing flexibility for cable routing.

The Scanstrut DS-HD6 cable gland is specifically designed for passing cables with diameters of 5 mm and 6 mm.

Yes, a single cable can be used. The kit includes blank plugs that can be used to seal the unused opening, or if you are only using one of the two passages.

The deck pass-through is compatible with various deck and bulkhead materials, including soft materials like plywood, hard materials like fiberglass, hardwoods and acrylic, as well as metal surfaces such as steel and aluminum. Mounting methods vary depending on the material.

For installation, you will need the following tools:

A Pozidriv screwdriverA drillA hole saw or a 25 mm (1 inch) diameter drill bitA 2.5 mm (3/32”) or 3 mm (1/8”) drill bit depending on the materialSilicone (not included)

You must select the gland with the diameter closest to that of your cable. The kit includes 5 mm and 6 mm glands, as well as blank glands for precise adaptation.

The kit includes four self-tapping screws #6 x 16, as well as one M5x10 bolt (black).

For soft materials like plywood, drill pilot holes of Ø2.5 mm (3/32”) and use the supplied n°6 self-tapping screws.

For hard materials such as fiberglass, hardwoods, or acrylic, drill pilot holes of Ø3 mm (1/8”) and use the provided #6 self-tapping screws.

For metal surfaces such as steel or aluminum, drill pilot holes of Ø3 mm (1/8”). It is recommended to use an M3 countersunk bolt over 12 mm long with a washer and Nyloc nut (not included).

Yes, a cutting template is included in the installation instructions to help you precisely mark the 25 mm hole location and mounting points.

Yes, it is important to deburr the drilled hole to ensure a smooth and clean surface before installing the deck gland, which contributes to better watertightness.