Daugkabelių mažo profilio praėjimo lizdas iki 15 mm skersmens kabeliams – juodai anoduotas

This is an advanced sealing device designed to route multiple cables through a boat’s deck or bulkheads while providing waterproof protection. It features a low-profile design and black anodized finish, making it ideal for marine environments.

The "Low Profile" design means the deck-penetrator has minimal height above the deck, reducing clutter and snagging hazards. Its installed height is only 18.5 mm (0.73").

The deck gland is made from a robust material with a black anodized finish. This anodization provides high resistance to corrosion and UV, ensuring optimal durability in the marine environment.

Yes, this is a marine-grade product from the Scanstrut brand, known for its durability and resistance to maritime conditions, including corrosion and UV exposure.

Yes, a cutting template is provided with the through-hull fitting to simplify the precise drilling and cutting required for installation on the deck or bulkhead.

A 35 mm (1 3/8") diameter hole is required to properly install the deck gland into the mounting surface.

For installation, you will need the following tools:

A 2.5mm (3/32"), 3mm (1/8") or 4mm (5/32") drill bit for pilot holes, depending on the material. A hole saw or a drill with a 35mm (1 3/8") bit for the main hole. A Pozidriv screwdriver. Marine-grade silicone for sealing. A jigsaw may also be useful for cutting.

The deck gland is supplied with four screws of type #6 x 19mm. These screws are suitable for mounting on soft or hard materials such as plywood, fiberglass, hardwood, or acrylic.

It is recommended to freeze the rubber bung before drilling. The hole diameter in the bung should be calculated by adding 1.5 mm to the cable diameter you intend to pass through, i.e.: hole diameter = cable diameter + 1.5 mm.

The drill bit diameter for pilot holes depends on your deck material:

For soft materials (e.g., plywood), use a 2.5mm (3/32") drill bit.For hard materials (e.g., fiberglass, hardwoods, acrylics), use a 3mm (1/8") drill bit.For metal (e.g., steel, aluminum), use a 4mm (5/32") drill bit.

Yes, this deck pass-through is compatible with a wide range of deck materials, including fiberglass, hardwoods, plywood, and acrylic. The included screws are suitable for these materials. For installations on metal, specific fasteners are recommended but not included.

Yes, this cable gland is specifically designed as a "multi-cable gland". The rubber bung can be precisely drilled to fit each cable individually, allowing multiple cables of varying diameters to pass through, provided they fall within the 1.5 mm to 15.0 mm range and space permits.