Rozszerzenie analogowe H5000

The H5000 analog expansion module is used to integrate additional sensors that provide analog or pulse signals into your B&G H5000 navigation system. It converts these signals so they can be read on the NMEA 2000 network, allowing you to display custom data such as rudder angle, mast rotation, or load cell sensor voltage.

You can connect up to eight sensors in total. The module has:

Six analog inputs for 0-5V sensors. Two pulse inputs for TTL 0-5V sensors.

No, the analog extender is specifically designed to work with a B&G H5000 central processing unit (CPU). It integrates into the NMEA 2000 network of this system to transmit sensor data.

Yes, you can connect third-party sensors. The key point is that their output signals are compatible with the module’s inputs, i.e., 0–5V analog signals or 0–5V TTL pulse signals.

The module is powered directly from the NMEA 2000 network bus. It does not require a separate power cable, which simplifies installation. Its power consumption is equivalent to 1 LEN (Load Equivalency Number) on the network.

Yes, the H5000 analog extender is capable of powering the connected sensors, simplifying the overall wiring of your installation.

The H5000 analog extension has an IP66 protection rating. This means it is fully protected against dust and powerful water jets, making it suitable for demanding marine environments.

Configuration, calibration, and diagnostics of connected sensors are performed via the H5000 system's web interface. You can access it from a web browser on a computer, tablet, or smartphone connected to your boat's network.

You can connect a wide range of sensors, for example:

Rudder angle sensorsRudder rotation sensorsLoad sensors (load cells)PotentiometersAnalog-output wind transducers / vane anemometersPulse-output speed sensors

The module’s typical power consumption is 0.6 Watts, which corresponds to a 50 mA load at 12V. On the NMEA 2000 network, this equals 1 LEN (Load Equivalency Number).

The module has the following dimensions: 61 mm (width) x 131 mm (height) x 45 mm (depth). Its weight is 0.17 kg.

The H5000 analog extension operates with a supply voltage of 12V DC, provided by the NMEA 2000 network. The accepted operating range is 10 to 16V DC.

The module uses a standard NMEA 2000 Micro-C connection port to connect to your instrument system's main network.

The analog extension is specifically designed to interface with sensors that output voltage signals (0-5V) or pulses. The serial extension, on the other hand, is used to connect devices that communicate via serial data protocols, such as NMEA 0183.

Yes, using the H5000 analog extension requires it to be connected to an H5000 central processing unit (CPU). The CPU processes the data sent by the module and makes it available to the rest of the system.

You can install the module anywhere on the backbone of your NMEA 2000 network, provided it is in a protected and accessible location for sensor connections.

Yes, the H5000 analog extension is compliant with IEC/EN 60945, which specifies requirements for maritime navigation and radio communication equipment.

The module converts analog and pulse signals into digital data. This data is then transmitted via the CAN-bus network, NMEA 2000 compatible, to the H5000 central processor which distributes it to displays and other system devices.

Yes, via the H5000's web configuration interface, inputs can be assigned to predefined functions (such as 'Rudder Angle') or receive custom names defined by the user for maximum flexibility.