Sterownica bezpiecznikowa 6-pozycyjna – czarna, wodoszczelna

The Blue Sea 6-position circuit breaker panel (PN 8373) has overall dimensions of 114.30 x 190.50 mm (4-1/2 x 7-1/2 inches).

Yes, this panel is designed to be water-resistant. It can withstand the typical water exposure encountered on deck, such as salt spray, rain, hose-downs, and momentary immersions. The detailed description mentions IP66 certification.

This circuit breaker panel is a 6-position model, meaning it can manage six separate electrical circuits.

The panel is made of 2.54 mm (0.100") thick 5052-H32 aluminum alloy. It is UV-stabilized, fire-retardant, and corrosion-resistant with a black textured polyurethane finish.

This panel is designed to operate with 12 V or 24 V DC electrical systems.

The maximum cumulative current capacity of this circuit breaker panel is 45 amperes.

Each circuit is equipped with 15 amp push-button circuit breakers as standard. The maximum capacity for switches and circuit breakers is 20 amps for 12-volt systems and 15 amps for 24-volt systems.

Yes, Contura-type ON-OFF switches integrate LED indicators. These LEDs have a nominal lifespan of 100,000 hours at half-life.

The panel has a textured black polyurethane finish.

The panel depth is 69.90 mm (2-3/4 inches).

No, this panel is designed for vertical mounting only.

Before starting the installation, it is imperative to disconnect the main positive cable from all batteries and unplug the AC shore power cord from the boat to eliminate any risk of short-circuit or electric shock.

Yes, a sealing gasket is included to ensure a watertight connection between the panel and the mounting surface. It must be installed and the panel firmly screwed in place.

The positive power cable (red) must be sized for a 3% voltage drop at the panel’s rated capacity of 45 amperes, or at the maximum current to be carried through the panel, whichever is lower. It is recommended to size the cable for the panel’s full capacity, which in most cases will require at least an 8 AWG wire for a 10-foot run between the panel and batteries in a 12-volt system.

The positive wire (red) of each branch circuit must be connected to the load terminal of the corresponding switch. The negative wire (yellow) of each branch circuit must be connected to a DC negative bus, such as a Blue Sea Systems PN 2301 BusBar PN or MiniBus PN 2304.

Yes, 60 base labels are provided for branch circuits, to be applied in the recessed area at the front of the panel.

To ensure waterproofing, the supplied gasket must be correctly positioned between the panel and the mounting surface. All surfaces must be clean and free of debris. The panel must then be firmly screwed down using the supplied mounting screws.

Any Blue Sea Systems product a customer is not satisfied with can be returned for a refund or replacement at any time.