Fusion EL Classic 6.5" 80 W black speakers (pair)

These 6.5-inch marine speakers have the following main specifications:

RMS power: 20 WPeak power: 80 WImpedance: 4 OhmsFrequency response: 45 Hz to 16 kHzSensitivity: 88 dBProtection rating (front): IP65

No, these Fusion EL speakers are from the Classic black non-illuminated edition. They are not equipped with LED lights.

These speakers are from the Classic edition and feature black grilles, offering a timeless and elegant look that blends well with most boat interiors.

These speakers have a nominal power (RMS) of 20 W and a maximum power (peak) of 80 W per speaker.

These speakers have an IP65 rating for the front. This means they are protected against dust and low-pressure water jets from all directions, making them suitable for marine environments.

For installing these speakers, you will need the following tools:

A power drillA bit (size varies depending on the surface material)An appropriate saw or utility knife to cut the surface materialA Phillips screwdriverWire strippersMarine-grade fully tinned 16 AWG (1.3 to 1.5 mm²) speaker wire6.3 mm and 4.8 mm female spade connectors (recommended)Crimping toolMarine sealant (optional)

Do not print your own mounting template. Use the template provided in the product box to ensure precise cutting. If you choose to print the template, make sure to print it "at actual size" on paper large enough to avoid any dimensional errors.

The rear of the speakers is not waterproof and must be protected from moisture at all times. Choose a mounting location that shields the rear of the speaker from any exposure to moisture. If speakers are mounted in an area exposed to weather or water, they must be installed on a vertical surface. Moisture exposure to the rear of the speaker can lead to failure and void the warranty.

Use 16 AWG (1.3 to 1.5 mm²) fully tinned marine-grade speaker wire to connect speakers to your stereo system.

No, these speakers must be mounted on a vertical surface if the location is exposed to weather or water. Mounting on a horizontal surface (facing upward) can lead to water pooling inside and around the speaker, causing damage over time.

To install the grilles:

Once the speakers are mounted, hold the grille with the Fusion logo at the bottom (6 o'clock position). Turn the grille counterclockwise by about 30 degrees (the Fusion logo should be at the 5 o'clock position). Place the grille on the speaker and turn it clockwise to secure it. Alternatively, align the Fusion logo at the 6 o'clock position and press to snap the grille into place.

No, it is important not to apply any grease or lubricant on the screws when securing the speakers to the mounting surface. Grease or other lubricants can damage the speaker.

Yes, it is strongly recommended to have your audio system installed by a professional installer. This ensures optimal performance and helps avoid personal injury or property damage.

Yes, these speakers are designed with a standard 4 Ohm impedance, making them compatible with most marine stereo systems and amplifiers designed for this impedance.

The speaker wires are terminated with male spade connectors. For optimal connection, it is recommended to use female spade connectors (not included) to connect the speaker wire to the speaker terminals.

The warranty on these speakers may be void in the following cases:

Exposure to moisture on the rear of the speaker, which is not waterproof.Damage to terminals or connections due to inadequate grounding protection or short circuits.Failure to follow the provided installation instructions, including mounting and wiring.