Black XS 6.5" 200 W RGB tower speakers (pair)

These marine tower speakers have a maximum power output of 200 W.

The RMS (Root Mean Square) power of these speakers is 50 W.

No, mounting brackets for Fusion XS speakers are sold separately. Each type of mounting bracket includes its own specific installation instructions.

Use 16 AWG (1.3 to 1.5 mm²) or thicker marine-grade tinned copper speaker cable to connect speakers to your stereo or amplifier. Speaker cable is not included.

These True-Marine speakers are covered by Fusion’s 3-year limited global consumer warranty.

If you choose not to install an LED controller, you can achieve a static LED color by connecting LED wire combinations to ground:

Red: Red wire
Green: Green wire
Blue: Blue wire
Yellow: Red and green wires combined
Magenta: Red and blue wires combined
Cyan: Blue and green wires combined
White: Red, green, and blue wires combined
The positive wire must be connected to the LED cable’s black wire via an appropriate fuse.

These marine tower speakers have a 6.5-inch diameter.

The nominal impedance of these speakers is 4 ohms.

The frequency response of these speakers is 80 Hz to 18 kHz.

It is recommended to install an LED lighting controller module with these speakers to turn the LEDs on and off, change colors, and create lighting effects. If you choose not to install one, you can set a static color by connecting the LED wires directly to the power source.

To clean your speakers:

Clean any salt residue with a damp cloth soaked in fresh water.Use a mild detergent to remove heavy salt buildup or stains.Do not use harsh or solvent-based cleaners, as this could damage the product and void the warranty.

If necessary, you will need to drill a 12 mm (1/2 in) cable pass-through hole in the wake tower or deck.

Speaker wire polarity is as follows:

White wire: Positive (+)
White wire with a black stripe: Negative (-)

The supply voltage for the LEDs in Sport model speakers is 10.8 to 16 Vdc.

The basic tools required for installation include:

A power drillA 12 mm (1/2 in) drill bitWire strippersAdditional materials such as speaker wire, LED wire, an inline fuse, and mounting brackets are also required but not included.

Yes, after installation, it is recommended to run the connected speakers at low to moderate volumes for the first few hours of use. This helps improve overall sound by gradually breaking in the moving components of new speakers, such as the cone, spider, and surround.

No, it is important not to use harsh or solvent-based cleaners on the speakers. Using such cleaners could damage the product and void the warranty.