M6-650X-S-GmTi-i flush-mount marine speakers

These speakers are 6.5-inch marine-grade coaxial 2-way flush-mount models from JL Audio’s M6 series. They are optimized for outdoor sound reproduction and feature a titanium Sport grille.

The RMS power of these M6-650X speakers is 75 W.

The frequency response of the M6-650X speakers is 55 Hz to 25 kHz.

The nominal impedance of these speakers is 4 ohms.

Yes, these Sport model speakers are equipped with integrated LED lighting.

The required cutout diameter for installing the M6-650X speakers is 127 to 133 mm (5.00 to 5.25 inches).

The required mounting depth for these speakers is 76 mm (3.00 in).

You must install an inline fast fuse on the positive wire of the LED cable. For the M6-650X model, the fuse rating must be 500 mA.

To select a static LED color without a controller, you can connect specific combinations of LED ground wires to the negative ground (-). Here are the combinations:

Red: red wireGreen: green wireBlue: blue wireYellow: combined red and green wiresMagenta: combined red and blue wiresCyan: combined blue and green wiresWhite: combined red, green, and blue wiresThe LED positive wire (+) must be connected to a 12 V DC power source via an appropriate fuse and an isolating switch or circuit breaker.

The recommended RMS amplifier power for the M6-650X speakers is 25 to 150 W per channel.

The required supply voltage for the LEDs (Sport models only) is 10 to 14.4 VDC.

The speaker’s front face is protected against water ingress. However, the rear of the speaker, including all connected components and wiring, is not waterproof and must be shielded from moisture.

To avoid damaging the speaker and voiding the warranty, it is critical to protect the rear of the speaker from any moisture exposure. If speakers are mounted outdoors, they must be installed well above the waterline and on a vertical surface to prevent water accumulation.

Exposure of the rear of the speaker to moisture can cause component failure. Additionally, this voids the product warranty.

For #8 screws, pilot hole recommendations for fiberglass are:

For fiberglass with a thickness of 0.125 inches or less: 7/64 inches
For fiberglass thicker than 0.125 inches: 1/8 inch

The charging current for the LEDs in the M6-650X model at 14.4 VDC is 324 mA.

Yes, continuous exposure to sound pressure levels above 100 dBA can result in permanent hearing loss. It is recommended to limit listening time at high volume and consult a professional if you experience ringing in the ears or muffled speech.

Yes, to avoid serious injury or damage to the audio system and the vessel, disconnect the vessel's audio system power supply before starting installation of the device.

Use 20 AWG (0.5 to 0.75 mm²) or thicker wire to connect LEDs to the power source.

Yes, the use of certain LED colors, such as red and green, may violate laws, regulations, and standards regarding the use and/or operation of marine navigation lights. It is the user's responsibility to comply with all applicable laws, regulations, and standards.