JL Audio M6-880X-S-GmTi-i flush-mount marine speakers

The total diameter of the JL Audio M6-880X-S-GmTi-i flush-mount marine speakers is 224 mm (8.80 inches).

To install the JL Audio M6-880X-S-GmTi-i speakers, you must cut an 187 mm (7.375 inches) diameter hole.

The JL Audio M6-880X-S-GmTi-i flush-mount marine speakers have an RMS power rating of 125 W.

The recommended amplifier power for JL Audio M6-880X-S-GmTi-i speakers is 50 to 250 W per channel (RMS).

The nominal impedance of the JL Audio M6-880X-S-GmTi-i flush-mount marine speakers is 4 ohms.

The sensitivity of the JL Audio M6-880X-S-GmTi-i flush-mount marine speakers is 90.5 dB (measured at 1 W/1 m).

The front of the speaker is protected against water ingress. However, the rear of the speaker, including all connected components and wiring, is not waterproof and must be protected from moisture.

If you mount the speakers in an area exposed to weather or water, you must install them on a vertical surface. If you mount them on an upward-facing horizontal surface, water can accumulate and cause damage over time.

To avoid potential injuries, always wear safety glasses, hearing protection, and a dust mask when drilling, cutting, or sanding. Additionally, disconnect the boat's audio system power supply before starting the installation.

To wire the LEDs, you must connect all 12 Vdc wires to a fuse at the power source end of the cable. The positive (+) yellow wire from the LEDs must be connected to a 12 Vdc power source via an isolator switch or circuit breaker to turn the LEDs on and off. The LED ground wire, or a combination of ground wires, must be connected to the negative ground (-).

A 750 mA inline fast fuse must be installed on the positive wire at the power supply end of the LED cable for each M6-880X-S-GmTi-i speaker.

The required supply voltage for the LED displays in Sport models, such as the M6-880X-S-GmTi-i speakers, is between 10 and 14.4 Vdc.

The charge current for the LEDs in the JL Audio M6-880X-S-GmTi-i speakers is 486 mA at 14.4 Vdc.

Yes, you can select a static color for the LEDs without installing a remote control. Simply connect specific LED color wires to the negative ground (-).

Red: Connect the red wire to ground.Green: Connect the green wire to ground.Blue: Connect the blue wire to ground.Yellow: Combine the red and green wires to ground.Magenta: Combine the red and blue wires to ground.Cyan: Combine the blue and green wires to ground.White: Combine the red, green, and blue wires to ground.

Yes, the product contains magnets that may interfere with certain electronic devices and medical devices. It is recommended to consult your doctor and the manufacturer of your medical device if you have any questions, and to use the product with caution near electronic devices.

Yes, it is strongly recommended to have your audio system professionally installed to ensure optimal performance.

Continuous exposure to sound pressure levels above 100 dBA may result in permanent hearing loss. The volume is typically too high if you cannot hear people talking around you. Limit the time spent listening at high volume and have your hearing checked if you experience ringing in the ears or muffled speech.