M3-650VeX-Gw-S-Gw-i Marine Tour Speakers

Each M3-650VeX speaker has a continuous RMS power output of 60 Watts per channel.

The frequency response of these speakers is 100 Hz to 25 kHz with a tolerance of ± 3 dB.

The nominal impedance of the system for the M3-650VeX speakers is 4 Ohms.

The system's efficiency is 89.5 dB at 1 Watt / 1 meter.

The enclosure dimensions are as follows:

Enclosure diameter (A): 179 mm (7.03 in)Enclosure depth (B): 156 mm (6.16 in)

The total height, including the mounting bracket receiver (C), is 185 mm (7.27 inches).

Yes, the M3-650VeX models are equipped with built-in RGB multicolor LEDs for vibrant accent lighting.

Installing these speakers requires using JL Audio® mounting brackets (sold separately). No other installation method should be attempted.

For audio connections, 16 AWG wiring is recommended. The wire with the '+' symbol is for the speaker positive, and the unmarked wire is for the speaker negative.

Yes, it is mandatory to install a fast inline fuse at the end of the power source for each Yellow (+12V) LED connection of the speaker. Failure to comply with this requirement may result in fire, property damage, or serious injury.

The recommended fuse value for the M3-650VeX LEDs is 150 mA.

The current drawn by the LEDs of the M3-650VeX is 108 mA at 12V DC.

No, it is strongly advised against connecting the LED lights of the speakers to the boat's navigation lighting circuits.

The recommended RMS amplifier power per channel for these speakers is 20 to 120 Watts.

Yes, adjustable RGB lighting control can be achieved using an RGB lighting controller (sold separately). It is recommended to use the JL Audio marine lighting controller (MLC-RW) for optimal performance.

No, these speakers must not be connected to 24V electrical systems. They are designed to operate within an LED voltage range of 10 to 14.4V DC.

You can get up to seven different LED color combinations by wiring individual wires or a combination of wires to a negative ground. The available colors are red, green, blue, yellow (red and green), magenta (red and blue), cyan (green and blue), and white (red, green, and blue).

No, you must not attempt to remove the LEDs from the speakers. The LEDs are permanently fixed, and any attempt to remove them will cause damage not covered by the warranty.

The M3-650VeX speakers are supplied with two Lexan logo appliqués.

Your JL Audio M3-650VeX-Gw-S-Gw-i marine tower speakers feature multicolor RGB LEDs for dynamic accent lighting. There are two main methods to control these LEDs:

With an RGB lighting controller (sold separately): This method provides adjustable color and effect control. For optimal performance, JL Audio recommends using its marine lighting controller (MLC-RW). When selecting a controller, ensure its output capacity is not exceeded by the total amperage demand of all LED circuits. By direct wiring: You can wire individual wires or a combination of wires to achieve up to seven different LED color assortments (Red, Green, Blue, Yellow, Pink, Aqua, White). All YELLOW wires (+12V) must be connected in parallel to a switched +12V power source. It is recommended to use a minimum 16 AWG wire gauge for each LED connection circuit. LED activation can be done via an existing cabin/indoor lighting circuit or a dedicated rocker/toggle switch. A fast-acting fuse must be installed at the power source end of each YELLOW (+12V) LED power wire from the speaker, sized according to the total amperage demand of all LED circuits. Note that the LEDs are permanently fixed and any attempt to remove them will cause damage not covered by the warranty.