Kaablikinnas CableClam 1.40"

Blue Sea Systems' CableClam 1.40" is designed for cable management and protection. It provides a watertight cable pass-through solution for marine installations, allowing safe penetration of decks or bulkheads while protecting the electrical system from the marine environment.

The overall dimensions of the CableClam 1.40" are as follows:

Length: 2.67 inches (67.70 mm)Width: 1.50 inches (38.16 mm)Height: 1.02 inches (25.86 mm)Base: 1.12 inches (28.33 mm)

Yes, the CableClam 1.40" is specifically designed for marine applications. Its design ensures watertightness and resistance to elements essential for recreational or commercial vessels.

Installing the CableClam 1.40" involves several steps:

Drill through the gasket with a sharp bit the same size as the cable, keeping the hole wet during drilling. The hole will be slightly smaller than the cable.Use a sharp razor knife to slit the gasket from its edge to the center hole.Attach the deck ring and gasket to the surface using #8 screws.Slide the compression ring onto the cable.Thread the cable through the gasket slit.Press the gasket into the compression ring.Tighten the compression ring to the deck ring by screwing each screw a few turns at a time, without over-tightening.

The CableClam 1.40" consists of the following components:

A compression ringA sealing gasketA deck ring

For fixing the CableClam 1.40" deck ring to the surface, use #8 screws.

Yes, it is necessary to drill the sealing gasket. You must drill a hole with a drill bit the same size as the cable, ensuring the hole is slightly smaller than the cable. Then, use a razor knife to split the gasket from its edge to the central hole to insert the cable.