6 položaja - Siva škriljevina

The BLUE SEA 8053-BSS waterproof DC distribution panel is designed for electrical distribution aboard vessels. It provides six positions for circuit protection and switching and is specifically built for marine environments where water resistance is critical.

The panel is made of 5052-H32 aluminum alloy, 0.100 inch thick.

The panel has a graphite textured two-part polyurethane finish and has undergone chemical treatment per Mil Spec C-5541C.

This distribution panel provides six positions for circuit protection and switching.

The fuse holders accept 1-1/4" x 1/4" AGC (fast-blow) and MDL (slow-blow) glass fuses, which are commonly available.

The panel is supplied with pre-installed 15 amp AGC (fast-acting) fuses.

Yes, this panel is water-resistant. It can withstand water exposure typically encountered in deck applications, such as salt spray, rain, pressure washing, and brief immersions.

Each switch is equipped with a circuit indicator LED that lights up to show the circuit is live.

The LEDs integrated in the switches are rated for a lifespan of 100,000 hours at half-life.

The overall dimensions of the panel are 133.40 x 190.50 mm (5-1/4 x 7-1/2 inches).

The panel is compatible with 12 V or 24 V DC systems.

Each switch and fuse holder is rated for a maximum current of 20 amperes for 12-volt systems and 15 amperes for 24-volt systems.

The total cumulative capacity of the panel is 45 amperes.

No, this panel must not be installed in explosive environments such as gasoline engine rooms or battery compartments, as the switches are not ignition-protected.

Before starting the installation, it is imperative to disconnect the main positive cable from all batteries and the AC shore power cord from the boat to eliminate any risk of short-circuit or electrocution.

A sealing gasket is included and must be placed between the panel and the mounting surface. The panel must be firmly screwed in to ensure a water-resistant installation.

The positive power cable must be sized for a 3% voltage drop at the panel’s full capacity (45 amperes), or at the maximum amperage to be carried in the installation, whichever is lower. It is recommended to size the cable for the panel’s full capacity, which typically requires at least an 8 AWG cable for a 10-foot run in 12-volt systems.

Yes, a properly sized fuse or circuit breaker must protect the main positive power cable.

Positive cables (red) from secondary circuits must be connected to the load terminals of each switch. Negative cables (black) from each secondary circuit must be connected to a DC negative bus, such as the Blue Sea Systems MiniBus PN 2304.

Yes, 30 basic labels are provided for secondary circuits. An extended label set of 120 labels (PN 8039) can be ordered separately from your marine supplier if additional labels are required.