Autopilotas ST1000+ Raymarine

The ST1000+ autopilot is specifically designed to equip sailboats with a maximum displacement of 3000 kg (6600 lb).

Two dimensions are critical to ensure proper autopilot operation:

Dimension A: 589 mm between the mounting socket and the tiller pin. Dimension B: 460 mm between the rudderstock axis and the tiller pin.

The ST1000+ is very energy-efficient. On a 12V DC supply, it draws approximately 40 mA in standby mode, and up to 90 mA when the screen backlight is set to maximum.

Yes, it is equipped with NMEA0183 and SeaTalk interfaces. This allows it to receive heading, wind, and GPS position data from other compatible navigation instruments.

The autopilot offers four main modes to adapt to your sailing:

Standby: the autopilot is on standby, you steer manually.Auto: the autopilot automatically maintains the set heading.WindTrim: the autopilot maintains a constant angle relative to the apparent wind.Track: the autopilot automatically follows a route to a waypoint defined on your GPS.

The ST1000+ is designed for boats up to 3000 kg with a worm drive and an 8-second response time. The ST2000+ is suitable for boats up to 4500 kg, uses a more robust recirculating ball system, and offers a faster 4.5-second response time.

The AutoSeastate function automatically adjusts the pilot's dead zone based on sea conditions. This optimizes course holding while reducing unnecessary rudder movements, which lowers power consumption and mechanical wear.

If your cockpit configuration does not allow for the standard 589 mm dimension, extension rods (from 25 mm to 152 mm) and cantilever mounting brackets are available as options to perfectly adapt the installation to your sailboat.

The ST1000+ autopilot requires a continuous power supply between 10 V and 15 V DC. It must have its own dedicated power source and cannot be powered solely by the SeaTalk network.

If the screen displays a rotating series of dashes, it means the compass deviation correction procedure is in progress.

This behavior usually indicates that the rudder gain is set too low. You need to increase this parameter in the autopilot calibration menu to achieve a more responsive response.

An overshoot (oversteer) means the rudder gain is set too high. Reduce the rudder gain level in the calibration settings to stabilize the course.

Yes, calibrating the internal compass during commissioning is mandatory. The procedure involves slowly turning the boat (under 2 knots) in circles so the autopilot can automatically correct for local magnetic deviation.

The "Err" message indicates that the connected GPS receiver has lost its position fix. You must check your GPS equipment to restore signal reception.

Yes, by activating Track mode, the autopilot uses its NMEA 0183 or SeaTalk connection to receive data from your GPS chartplotter and automatically follow the route to the next waypoint.

To regain manual control of the tiller or wheel at any time, press the Standby button to put the autopilot in standby mode, then manually remove the drive rod from the helm spindle.

If the screen is blank, this indicates a lack of power supply. Check that the autopilot is properly connected, inspect the condition of your battery, as well as the fuse or circuit breaker for the autopilot’s dedicated circuit.

The WindTrim mode allows the autopilot to maintain a constant angle relative to the apparent wind instead of following a fixed compass heading. For this mode to work, a wind transducer/vane anemometer must be connected to the onboard network and transmit its data to the autopilot.

Yes, to avoid interference, it is strongly recommended to install the autopilot:

At least 1 meter away from radio transmission equipment (such as a VHF) and their cables.More than 2 meters from the radar's radiation beam.

The "CAL OFF" message appears when access to the calibration menu has been locked to prevent accidental modifications. You must unlock this safety setting to adjust the autopilot's advanced parameters.