Radaro maitinimo kabelis QUANTUM 10 m

This cable is designed exclusively to supply power to your Raymarine Quantum radar antenna from your boat's distribution panel.

This specific model (reference A80309) is 10 meters long, which is generally ideal for installation on a davit or the mast of a mid-sized sailboat.

No, this is a cable strictly dedicated to power supply. It is suitable if you use your Quantum radar in Wi-Fi mode for data transmission to your chartplotter.

Yes, the cable is fitted with an overmolded connector that ensures perfect waterproofing against spray and rain once properly connected to the radome.

Yes. The cable jacket is designed to withstand UV rays and extreme marine environments, which is essential for outdoor installations at the masthead.

Using the original cable ensures that your radar's performance is maintained and prevents voltage drops along the line, which could cause unexpected restarts or a loss of the device's range.

The Raymarine manufacturer part number for this 10-metre power cable is A80309.

Yes, this power cable is fully compatible with all Raymarine Quantum radars of the first generation.

Yes, it is fully compatible with the Quantum 2 radar range featuring Doppler effect.

No, this cable is specifically designed for the Quantum pulse-compression radar range and will not fit older analog models.

No, the overmolded connector is proprietary and designed to fit Raymarine equipment only.

Yes, this is the ideal choice. Since the radar transmits image data wirelessly over Wi-Fi, you only need this cable to supply the electrical power required for its operation.

Simply insert the overmolded connector into the dedicated power port located under the Quantum radome, then tighten the locking ring to secure and ensure waterproofing.

If 10 meters are not enough, it is strongly discouraged to splice the cable to extend it, as this can cause voltage drops. Raymarine offers this cable in longer lengths suitable for large vessels.

Yes, you can cut the excess cable on the electrical panel side (stripped wire side) to neatly fit your installation. However, leave a small safety margin.

The end opposite the radar has exposed wires that must be connected directly to your electrical distribution panel (12V or 24V), respecting polarity.

Yes, it is essential to protect the electrical line. You must install a fuse or a thermal circuit breaker correctly sized according to the installation manual of your Quantum radar.

It is recommended to run the cable inside a dedicated conduit within the mast to prevent chafing (rubbing) against moving halyards, and to secure it with cable ties at exit points.

Since this is only a direct current power cable (with no high-frequency data transmission), the risk of interference is very low. It is still advisable to follow standard separation rules with VHF antenna cables.

No, the connection on the radar side is hand-tightened using the integrated threaded ring. You will only need standard tools (wire strippers, screwdriver) for the final connection to the boat's electrical panel.