Płytka bezpiecznikowa wodoodporna WeatherDeck® 12 V DC – szara 4-pozycyjna

This waterproof fuse panel is specifically designed for open cockpit and flybridge applications, where robust protection of 12V DC circuits is required in demanding marine environments.

The WeatherDeck® fuse panel is designed to operate with 12V DC electrical systems.

This WeatherDeck® fuse panel model has 4 positions, allowing it to protect up to four separate electrical circuits.

The front panel is IP67 certified, meaning it is protected against immersion in water up to 1 meter deep for 30 minutes, provided it is correctly installed with the supplied sealing gasket.

15A ATO®/ATC® fuses are installed in each position of the panel. Other fuse ratings are available separately.

The maximum cumulative current capacity for the WeatherDeck® 4-position fuse panel is 60A.

The integrated bicolor LEDs illuminate the circuit labels to indicate their state: red for off, green for on, and no color if the fuse is blown.

Yes, the backlighting of the labels is compatible with DeckHand Dimmers, allowing independent control of lighting and dimming.

Yes, a set of square-format labels (reference 4215) is included with the panel to customize the identification of each circuit.

The panel’s faceplate (front cover), UV-stabilized and weather-resistant, clips on and off. It conceals the mounting screws once the panel is installed, providing a clean finish.

The panel can be mounted in any of the four possible orientations, providing installation flexibility.

The panel cover is made of UV-resistant thermoplastic, and the panel itself is made of UL-V0 flame-resistant thermoplastic.

Yes, the switches on the panel are not flameproof. The panel must NOT be installed in an explosive environment, such as a gasoline engine room or a battery compartment.

For basic wiring, connect the +12V DC power source to the busbar, the -12V DC negative to the quick-connect terminal marked “Negative”, and the positive side of each device to the output terminal of a switch. The negative side of the device must be connected to the DC negative.

Yes, switch guards are integrated into the panel's design to reduce the risk of accidental circuit activation.

The panel provides a function to power a 360° anchor light when the bow navigation lights are activated, while also allowing the anchor light to be turned on independently. To do this, connect the bow navigation lights to switch #2, install a 16 AWG jumper wire between the "NAV Diode" tab and the output terminal of switch #3, then connect the 360° anchor light to switch #3.

Yes, a cutting template is provided to facilitate the preparation of the opening required for the panel installation.

Blue Sea Systems guarantees its products for as long as you own them. This warranty covers the product for its lifetime.

The panel's flush-mount depth is 2.50 inches (63.50 mm).

The 4-position switch panel has a width of 3.88 inches (98.55 mm) and a height of 4.30 inches (109.22 mm).