Comutator numeric CC 10x10 A

The DC 10x10A digital switch is a decentralized input/output module designed for MasterBus networks. It allows control of up to ten DC channels, such as lighting, pumps, or onboard electronics, with a 10 A capacity per channel.

No, this product is now obsolete. It is offered here as a spare part for the maintenance and repair of existing marine electrical installations, avoiding the need to rewire the entire vessel.

This module operates over a voltage range from 8 to 30 V. It is therefore natively compatible with 12 V and 24 V battery banks.

Each individual output can support 10 A. However, it is possible to connect multiple outputs in parallel to support higher currents, up to a maximum of 100 A for the entire module.

Electrical safety is ensured by dual protection on each channel: a configurable software fuse at 10 A and a conventional hardware fuse at 15 A.

In case of network failure, a hardware manual reset (bypass) is possible directly on the device. The 15 A hardware fuses have positions allowing manual forcing of channel ignition or shutdown.

Yes, the module includes ten integrated dimmers. This allows you to program the dimming of the boat's lights directly from the system without needing to add external dimmers.

Also called "follow-me home" function, this is an automation that keeps the lights on for a short time after the switch is turned off, giving you time to leave the area safely.

For input connections, the module accepts cables up to 95 mm². For output connections, the maximum cable cross-section is 4 mm².

The switch has an IP21 protection rating. It is not waterproof and must be installed in a dry location, protected from rain, humidity, and condensation.

The module measures 40 x 229 x 110 mm (Height x Width x Depth) and weighs 0.75 kg. Its compact design makes it easy to integrate into the boat's electrical panels.

No, its electrical consumption on the DC side is extremely low. It is less than 2 mA when powered at 12 V or 24 V.

The device is equipped with a communication LED on the front panel. If it is continuously lit, the operation is normal. Different blinking patterns indicate the presence of voltage, an active alarm, or the manual forcing of an output.

Yes, control and configuration are done via the MasterBus network. You will need a compatible display, such as the MasterView Easy, or the MasterAdjust software on a PC connected via a USB interface.

Yes, it is entirely possible to directly connect a standard switch (On/Off) to the switch to generate an electrical signal and control an output, without necessarily needing to go through a digital display.

When a software fuse trips due to an overload, it can be easily reset remotely via the interface of your MasterBus display, without needing to physically access the module.

Yes, the module includes smart alarm functions. It emits an alarm signal on the MasterBus network if an overload is detected on any of its channels.

Yes, power input connections can be directly linked to a MasterShunt or a Mastervolt DC Distribution system for optimized wiring management.

By using the hardware bypass, the input is directly connected to the output via the 15 A fuse. Caution: this overrides software settings such as the dimmer. Additionally, raw input voltage will be applied to the connected device, requiring special attention if you have 12 V devices on a 24 V network.