M-MCPv3 Mounts for 2.25" Bar (pair)

JL Audio guarantees this product against defects in materials and workmanship for a period of two (2) years from the original purchase date.

The warranty does not cover damage caused by an accident, misuse, abuse, modification, or neglect of the product, failure to follow installation instructions, unauthorized repair attempts, or false statements by the seller. It also does not cover incidental or indirect damage, nor the cost of removing or reinstalling the unit. Cosmetic damage due to an accident or normal wear and tear is not covered.

No, this warranty is not transferable and applies only to the original buyer from an authorized JL Audio dealer.

This mounting bracket is designed to fit bars with a diameter of 2.25 inches.

This bracket is specifically designed for JL Audio ETXv3 sealed enclosure systems.

No, the swivel mounting brackets must be attached only to horizontal bars. The ETXv3 speakers must be mounted directly above (12 o'clock position) or directly below (6 o'clock position) a horizontal bar.

For better adhesion, clean the inside of the aluminum cap with acetone (not included). Apply a circular bead of silicone adhesive (included) inside the cap, about 1/2 inch (13 mm) from the outer edge. Align the aluminum logo cap to the desired rotation angle and press it onto the back of the enclosure. Use masking tape (not included) to hold the cap in place until the silicone cures (at least 24 hours).

If a different speaker angle is desired, remove the mounting screws and washers. Rotate the speaker to the desired angle, then reinstall it by tightening the screws in a cross pattern.

Rotate the speaker to the desired angle, install the 5/16 - 18 x 1/2" adjustment screw in the mounting base, and tighten it fully.

Yes, if the cable must be routed through the bar, adjust the mounting bracket angle until it is level, mark the speaker cable hole location, remove the entire bracket assembly, and drill a 1/2" (approx. 12.7mm) hole at the marked spot.

The speaker can rotate up to 205.5 degrees clockwise and 128.5 degrees counterclockwise.

No, swivel mounting brackets must be attached only to horizontal bars.

The technical document clearly states that these swivel mounting brackets are designed specifically for JL Audio ETXv3 sealed enclosure systems. There is no information regarding compatibility with other speaker models.

The aluminum logo cap must be aligned to the desired rotation angle before being pressed onto the back of the enclosure. It is recommended to hold it in place with masking tape until the silicone has cured (at least 24 hours).

The supplied in-line connectors are used to connect the red (+) and black (-) speaker cable exiting the ETXv3 speaker.

Yes, this mount is an original product from the JL Audio brand, as indicated by the product name, SKU, and supplier information.