Rokk Wireless Active wireless charger - 15W - On stand

The Scanstrut Rokk Wireless Active wireless charger delivers a maximum output power of 15W. It can also provide 5W, 7.5W, and 10W outputs. Actual output power depends on your phone model and its ability to accept fast charging.

Yes, the Scanstrut Rokk Wireless Active charger is perfectly suited to a marine environment. It has an IPX6 waterproof rating, meaning it is protected against powerful water jets from any direction, both at the front and rear of the device.

The Rokk Wireless Active charger is designed specifically for charging mobile devices compatible with the Qi standard. The output power may vary (5W, 7.5W, 10W, 15W) depending on your phone model.

Yes, this wireless charger can charge your phone through non-metallic protective cases up to approximately 3mm thick. Phone cases may slightly affect overall charging performance.

The Scanstrut Rokk Wireless Active charger requires an input voltage of 10 to 30V DC. It is therefore compatible with 12V and 24V marine electrical systems.

Installing the Rokk Wireless Active charger on its base involves the following steps:

Unpack the charger and insert the supplied installation template. Ensure there is enough space to open the charger jaws and that the installation area is flat and vertical.Use the supplied drilling template to mark and drill the cable pass-through hole (Ø 6mm) and the four pilot holes.Thread the cable through the hole.Apply sealant to the four mounting screws.Secure the product in place.Remove the installation template.It is recommended to disconnect power before installation and to use an appropriate fuse or circuit breaker between the power source and the product.

For installing the Rokk Wireless Active wireless charger on its base, you will need to drill:

One cable pass-through hole with a diameter of 6.0 mm (0.24”).Four pilot holes for mounting screws.The drilling template also indicates a minimum diameter of 42 mm (1.6”) for the charger body clearance and a maximum depth of 205 mm (8.1”) for rear clearance. A template is provided to simplify marking the drilling points.