Regulaator Deckhand – 24 V alalisvool 12 A

The BLUE SEA Deckhand 7509 dimmer is designed to digitally control the brightness of unregulated LEDs, incandescent and halogen bulbs in 24 V DC marine systems. It provides precise lighting management aboard.

This dimmer can control the brightness of:

Non-dimmable LED bulbsIncandescent bulbsHalogen bulbs

The Deckhand 7509 drive requires a nominal voltage of 24 V DC (direct current) to operate correctly.

The Deckhand 7509 variable speed drive operates within a voltage range of 18 V to 32 V DC.

The Deckhand 7509 drive’s maximum output current is 12 A.

The "bulb saver" function built into the Deckhand 7509 dimmer prevents premature aging of bulbs when the boat's batteries are being charged. This helps extend the lifespan of your bulbs.

The Deckhand 7509 autopilot has built-in overcurrent protection. If the unit stops working due to an overcurrent, simply correct the excessive load, then hold the autopilot switch down until the circuit flashes to reset it.

The Deckhand 7509 drive is designed to operate across a wide temperature range from −40°C to 85°C.

The Deckhand 7509 dimmer uses Pulse Width Modulation (PWM) for light intensity control.

Yes, the Deckhand 7509 dimmer has a memory that stores the last light intensity setting used.

The Deckhand 7509 drive's maximum parasitic current is less than 2 mA, indicating very low energy consumption in standby mode.

To activate the illuminated output mode and set the delay:

1-minute delay: Hold the switch in the upper (illuminated) position for 2 seconds. The lights will flash. Release the switch after the first flash, and the lights will remain on for 1 minute.2- to 5-minute delay: Hold the switch in the upper (illuminated) position for 1 to 4 seconds after the first flash. Release the switch after 2 to 5 flashes. The lights will remain on for 1 minute per flash, up to a maximum of 5 minutes.

Yes, the Deckhand 7509 variator is supplied with a momentary (ON)-OFF-(ON) switch.

Yes, the offset mounting feet of the Deckhand 7509 autopilot drive are designed to allow multiple drives to be mounted close to each other, optimizing installation space.

If the inverter stops working due to an overcurrent, you must first correct the excessive load. Then, hold the inverter's switch pressed until the circuit flashes to reset the built-in protection.

Yes, the Deckhand 7509 variator supports multiple switching locations, allowing you to control it from different points on your boat.

No, the Deckhand 7509 drive is specifically designed for 24 V DC marine electrical systems and operates within a range of 18 V to 32 V. It is not compatible with 12 V DC systems.

No, the Deckhand 7509 dimmer is designed to digitally control the intensity of unregulated LEDs, as well as incandescent and halogen bulbs.

The Deckhand 7509 autopilot drive complies with several regulatory standards, including:

E-markedISO 8846 (external ignition protection)SAE J1171 (external ignition protection)SAE J1455SAE J1113

Yes, the Deckhand 7509 drive complies with the external ignition protection requirements of ISO 8846 and SAE J1171 standards, ensuring safety in marine environments.