Tihendatud 6-kohaline kaitselülitipaneel – must

The Blue Sea 6-circuit breaker panel (PN 8373) has overall dimensions of 114.30 x 190.50 mm (4-1/2 x 7-1/2 inches).

Yes, this panel is designed to be waterproof. It can withstand the water exposure typically encountered on deck, such as salt spray, rain, hose-downs, and brief immersions. The detailed description mentions IP66 certification.

This circuit breaker panel is a 6-position model, meaning it can handle six separate electrical circuits.

The panel is made of 2.54 mm (0.100") thick 5052-H32 aluminum alloy. It is UV-stabilized, fire-retardant, and corrosion-resistant, with a black textured polyurethane finish.

This panel is designed to operate with 12 V or 24 V DC electrical systems.

The maximum cumulative current rating of this circuit breaker panel is 45 amperes.

Each circuit is equipped with 15 amp push-button circuit breakers as standard. The maximum rating for switches and circuit breakers is 20 amps for 12-volt systems and 15 amps for 24-volt systems.

Yes, the ON-OFF switches of the Contura type include built-in LED lights. These LEDs have a nominal lifespan of 100,000 hours at half-life.

The panel has a textured black polyurethane finish.

The panel’s flush-mount depth is 69.90 mm (2-3/4 inches).

No, this panel is designed for vertical mounting only.

Before starting the installation, it is imperative to disconnect the main positive cable from all batteries and unplug the AC power cord from the boat's shore power to eliminate any risk of short-circuit or electrocution.

Yes, a sealing gasket is included to ensure a watertight connection between the panel and the mounting surface. It must be installed and the panel firmly screwed in place.

The positive power wire (red) must be sized for a 3% voltage drop at the panel’s rated capacity of 45 amps, or at the maximum current that will be carried through the panel, whichever is lower. It is recommended to size the wire for the panel’s full capacity, which in most cases will require at least an 8 AWG wire for a 10-foot run between the panel and batteries in a 12-volt system.

The positive wire (red) of each branch circuit must be connected to the load terminal of the corresponding switch. The negative wire (yellow) of each branch circuit must be connected to a DC negative bus, such as a Blue Sea Systems PN 2301 BusBar or PN 2304 MiniBus.

Yes, 60 base labels are provided for branch circuits, to be applied on the recessed area at the front of the panel.

To ensure waterproofing, the supplied gasket must be correctly positioned between the panel and the mounting surface. All surfaces must be clean and free of debris. The panel must then be firmly screwed down using the supplied mounting screws.

Any Blue Sea Systems product that a customer is not satisfied with can be returned for a refund or replacement at any time.