Mastervolti-CZone ühenduskaabel 1 m

This cable bridges your Mastervolt power equipment with your CZone or NMEA 2000 marine network. It enables data transmission to monitor and control your devices from a compatible display.

This Mastervolt interconnect cable (part number 77060100) is exactly 1 metre long.

Yes, this cable is fully compatible with the NMEA 2000 network. It allows you to integrate your Mastervolt devices compatible with CZone directly onto your boat's NMEA 2000 backbone.

Yes, if your Mastervolt charger is CZone-compatible and your chartplotter is connected to the NMEA 2000 or CZone network, this cable will allow energy data to be displayed on your navigation display.

Installation is straightforward. Simply plug the proprietary end into the communication port of your Mastervolt device, and the other end into a free T-connector on your CZone or NMEA 2000 backbone.

Yes, to connect this cable to your main network (backbone), you will need a NMEA 2000 T-connector or a free port on your CZone interface module.

This cable transmits critical power data, including:

Battery voltageCharge or discharge currentOverall status of your Mastervolt batteries and devices

Yes, its robust design meets the strict requirements of marine environments, ensuring a reliable and secure connection even in harsh conditions aboard your vessel.

Although the physical connection is direct, software configuration via the CZone or MasterAdjust setup tool may be required for the device to be properly recognized and display the correct data on the network.

It is not recommended to modify or extend this adapter cable directly. If the distance exceeds 1 meter, it is better to add a T-connector to the NMEA 2000/CZone backbone near your Mastervolt device.

No, this cable is only for data communication (network). Your Mastervolt charger, inverter, or battery must have its own main power supply.

No, each Mastervolt-compatible device requires its own Mastervolt-CZone connection cable to be individually connected to the marine network.

This cable is specifically designed for Mastervolt devices with native CZone support. For devices operating solely on MasterBus, an interface or MasterBus to CZone/NMEA 2000 bridge will be required.

No, NMEA 2000 and CZone networks require a backbone architecture. The cable must be connected to a T-connector on the backbone, not directly to the display.

Yes, if you own Mastervolt equipment compatible with CZone and wish to integrate it into your centralized system for global monitoring, this adapter cable is required.

This cable is very light and weighs approximately 50 grams, which will have no significant impact on the total weight of your electrical installation.

The official reference for this 1-meter Mastervolt-CZone interconnect cable is 77060100.

Yes, the CZone/NMEA 2000 connection allows not only monitoring (data reading) but also bidirectional control of your compatible Mastervolt equipment from your displays.