Digitaalne näidik i50 Tridata

The i50 Tridata display consolidates three essential data types: depth (with shallow-water alarms), speed (current, maximum, average, log, and daily distance), and water temperature. It also includes a race start chronometer for regatta sailors.

Yes, the i50 range uses a high-contrast segmented LCD display. This technical choice, combined with large-sized digits and red backlighting, ensures maximum readability day and night, even in high-light conditions.

Yes. The i50 Tridata has been specifically designed to provide a direct and easy replacement for the older ST60 series. It maintains a similar footprint to fit seamlessly into existing dashboard cutouts.

Yes, the display is equipped with SeaTalk NG connectivity, which is Raymarine's standard compatible with the NMEA2000 network. It thus integrates easily into modern navigation systems.

Yes, the i50 Tridata maintains native backward compatibility with old SeaTalk 1 networks. This makes upgrading your instruments much easier without having to rewire your entire boat.

The device operates on a 12 V DC power supply (with a tolerance range from 10 to 16 V DC). It can be powered directly via the SeaTalk NG network.

No, one of the main advantages of its segmented LCD display is its very low power consumption. The display alone typically consumes less than 1 W, which helps preserve the batteries on your sailboat or powerboat.

Yes, the display has IPX6 waterproof certification. It is designed to withstand spray and breaking waves, making it perfectly suitable for outdoor installation in your boat's cockpit.

You can configure the units according to your preferences during calibration:

Speed: Knots (KTS), miles per hour (MPH), or kilometers per hour (KPH).
Distance: Nautical miles, statute miles, or kilometers.
Temperature: Degrees Celsius (°C) or Fahrenheit (°F).

To configure the shallow alarm, navigate to the depth page, then press and hold the Trip and Reset buttons simultaneously to enter setup mode. You can then set the desired alarm threshold to navigate safely.

The i50 Tridata is compatible with a wide range of analog depth, speed, and temperature transducers. This includes through-hull models such as the P120, B45, P319, as well as transducers that can be bonded inside the hull (P79) or on the transom (P66).

When the i50 Tridata is connected to a SeaTalk NG network, it can participate in a group illumination. You can assign it to a unit group (e.g., "Bar 1") so that all instruments in that group share the same backlighting level.

Yes, the i50 Tridata is designed for flush-mount installation. The front bezel can be easily removed by pulling on the edges, allowing the unit to be screwed directly to the bulkhead for a clean, aligned finish with your other instruments.

If the depth information is flashing, this means the display has lost the signal from the transducer. The displayed value is the last known depth. Check the connections of your depth sensor at the back of the device and ensure you are not in an area of strong turbulence or very aerated water.

No, the i50 series features push-button interface. This is a deliberate choice: it ensures intuitive and reliable navigation between data pages, even in rough sea conditions or when wearing gloves, where touchscreens can reach their limits.

Yes, if you are powering the SeaTalk NG network or the device directly from a battery, it is mandatory to install an inline 5-amp fuse (or equivalent thermal circuit breaker) on the positive (red) cable to protect your electrical installation.

It is recommended to use only a clean, damp cloth to wipe the screen. Never use abrasive products, acids, ammonia, or chemical solvents, as they could permanently damage the LCD screen's surface treatment.

Yes, the unit can operate in "Repeater" mode. If it is connected to a SeaTalk NG or SeaTalk 1 network where another instrument (or module) is already broadcasting depth and speed data, the i50 will display this information without requiring its own transducers connected at the back.