RCR – SD-kaardi ja USB-pesa lugeja

The RCR-SDUSB is a remote card reader designed as an accessory for Raymarine Axiom multifunction displays (MFD). It extends the connectivity of these MFDs by providing an SD card slot and a USB port.

The SD slot of the RCR-SDUSB is compatible with SD memory cards. For MicroSD cards, they must be inserted into an SD adapter (usually supplied with the MicroSD card) before use.

The USB port on the RCR-SDUSB is used to connect external USB storage devices, such as USB flash drives. It can also be used to charge small compatible USB devices.

No, it is important not to connect any device requiring an external power source to the USB port of the RCR-SDUSB. It is designed solely for charging small compatible devices.

The SD card slot is primarily used for loading marine electronic charts and transferring user data, such as waypoints and routes, to and from your Axiom MFD.

The RCR-SDUSB is specifically designed as a remote card reader for Raymarine's Axiom series multifunction displays (MFD).

The RCR-SDUSB is designed for surface mounting. Installation requires drilling holes in the mounting surface using the provided template, then securing the unit with four self-tapping screws (not included).

To assemble the unit, you will need four self-tapping screws of the appropriate size (not included). The drill bit and screw size will depend on the thickness and material of the mounting surface.

Yes, a mounting template (document number 87292) is provided to guide you in cutting and drilling the required holes on the mounting surface.

The RCR-SDUSB comes with an integrated cable measuring 1 meter (approximately 3.28 feet) for connection to your Axiom MFD.

The 1-meter integrated cable of the RCR-SDUSB must be routed through the mounting hole and connected to the accessory interface located at the rear of your Axiom multifunction display.

Yes, suppression ferrites are included and must be installed on the card reader cable. They are designed to reduce potential interference and prevent data corruption when reading from or writing to external storage.

Two of the suppression ferrites must be installed at 6 mm (0.24 inch) intervals from the end of the cable connector. The third ferrite must be placed 53 mm (2.09 inches) from the back of the chartplotter. Cable ties are also provided to secure them in place.

After installation, it is crucial to ensure that the card reader cover or door is firmly closed. This prevents water ingress and subsequent damage to the product.

Yes, a gasket must be attached to the rear of the chartplotter before inserting it into the cutout for installation.

The RCR-SDUSB is primarily designed to extend your Axiom MFD capabilities by providing access to electronic charts via the SD slot and allowing connection of USB storage devices or charging small devices via the USB port.

The RCR-SDUSB enhances the native capabilities of Axiom MFDs by providing a remote solution for storage and connectivity needs. It enables flexible data and chart management, optimizing access to critical onboard information.

The RCR-SDUSB is not specified as being supplied with an adapter. However, most MicroSD cards are typically supplied with a suitable SD adapter, which is required for use in the RCR-SDUSB's SD slot.

The RCR-SDUSB is specifically designed as an accessory for Raymarine Axiom multifunction displays (MFD), and compatibility with other brands is not indicated.

The part number or SKU for this Raymarine RCR-SDUSB chartplotter is A80440.