SmartSolar MPPT VE.Can 150/100 Tr RS

The SmartSolar MPPT 150/70 VE.Can is a solar charge controller designed by Victron Energy to optimize energy harvesting from photovoltaic installations. It uses an ultra-fast maximum power point tracking (MPPT) algorithm to maximize energy production, even under cloudy skies or partial shading.

The SmartSolar MPPT 150/70 VE.Can charge controller delivers a maximum conversion efficiency exceeding 98%.

The controller includes extensive electronic protections, including:

Protection against overheating and power reduction in case of high temperature.Protection against PV short circuits.Protection against PV reverse polarity.Protection against PV reverse current.

No, this controller is designed without a cooling fan, which contributes to its efficiency and silent operation.

Standby power consumption is less than 35 mA for a 12 V system and less than 20 mA for a 48 V system.

The controller stores trend data for 46 days, including:

Battery voltage, current, and temperature.Output current of the charger.Voltage and current from the PV array.

The controller can operate within a temperature range from -30 °C to +60 °C. It maintains its full nominal power up to 40 °C.

Yes, the regulator can initiate charging even if the battery has been discharged to zero volts. It can also reconnect a fully discharged Li-ion battery with an integrated disconnect function.

The charge controller's housing is blue (RAL 5012).

The charge controller (model MC4) has dimensions of 215 mm (height) x 250 mm (width) x 95 mm (depth) and weighs 3 kg.

The charge controller is compatible with 12 V, 24 V, and 48 V battery voltages, with automatic selection. For 36 V systems, the selection must be performed manually.

The maximum nominal PV power the charge controller can handle depends on the battery voltage:

12 V: 1000 W
24 V: 2000 W
36 V: 3000 W
48 V: 4000 W
If a higher PV power is connected, the charge controller will limit the input power.

The absolute maximum open-circuit voltage of the solar panels is 150 V under the coldest conditions. The maximum starting and operating voltage is 145 V.

Up to 25 units can be synchronized in parallel operation via the VE.Can interface. It is also possible to synchronize up to 10 units via Bluetooth.

Yes, the charge controller includes Bluetooth Smart, allowing wireless configuration, monitoring, and firmware updates via the VictronConnect app on a smartphone or tablet.

Yes, an optional SmartSolar plug-in LCD display can be connected. Simply remove the rubber gasket protecting the front port of the charge controller and plug in the display.

Yes, the controller is equipped with a VE.Direct interface that allows a wired connection to a Color Control GX, other GX products, a PC, or other devices for data communication and monitoring.

You can use a Smart Battery Sense, a BMV-712 Smart Battery Monitor, or a SmartShunt to send battery voltage and temperature (as well as current in the case of the BMV-712 or SmartShunt) to one or more SmartSolar charge controllers.

The autopilot is designed for indoor use in an unconditioned environment. It is rated with pollution degree PD3 and can operate up to an altitude of 5000 meters (with full nominal power up to 2000 meters).

The controller (MC4 model) has two pairs of MC4 connectors for PV panels. The maximum current per MC4 connector is 30 A. For the battery, it is equipped with 35 mm² / AWG2 terminals.