Kabel WS300/700 50m

This cable is specifically designed for wired wind sensors from the B&G brand, including the WS310 and WS700 series.

This cable is 50 meters long, which is approximately 164 feet.

Yes, the cable is supplied ready-to-use with pre-molded Micro-C male and female connectors at each end, ensuring simple installation and a watertight connection.

Yes. This cable is an NMEA 2000 cable and integrates seamlessly into B&G electronics ecosystems and standard NMEA 2000 networks.

The 50-meter length is specifically designed for sailboats with tall masts, ensuring a seamless connection between the masthead sensor and the onboard electronics without requiring an extension.

It is strongly discouraged to cut this cable. The connectors are factory-molded to ensure waterproofing and signal reliability. Modifying the cable could compromise its performance and integrity.

Yes, it is designed for the marine environment. Its thermoplastic jacket provides excellent protection against:

UV raysSalt waterMechanical stress such as mast vibrations and flexing

No, this cable is designed for wired sensors. Wireless models, such as the B&G WS320, communicate via Bluetooth and do not require this type of mast cable.

The manufacturer part number (SKU) for this cable is 000-14398-001.

Thanks to its "plug-and-play" design with pre-installed connectors, installation is simplified. It involves connecting the cable to the sensor on one end and to the boat's network on the other, then routing it through the mast.

This cable is fitted with specific molded connectors to link the WS310/WS700 wind sensor to the wired interface. The wired interface (not the mast cable) is equipped with a Micro-C connector for the NMEA 2000 network.

Yes, as an NMEA 2000 cable, it handles both the electrical power required for the wind sensor to operate and the data transmission to your navigation instruments.

Yes, this is an official B&G accessory cable, designed for optimal compatibility and reliability with their wind sensors.

This cable is specifically designed for B&G WS310 and WS700 sensors. Although Micro-C connectors are standard, functional compatibility with sensors from other brands is not guaranteed by the manufacturer.

The thermoplastic sheath serves as an outer protective layer. It shields internal conductors from physical damage, moisture, salt, and UV rays, thereby ensuring the cable's longevity in a marine environment.

One end connects directly to the wind sensor at the masthead. The other end plugs into the sensor’s interface or directly onto the backbone (backbone) of your NMEA 2000 network inside the boat.

Yes, if you have a B&G WS310 wired wind sensor and need to replace the mast cable, this is the official and adequate replacement part.

The cable is designed to be robust enough to withstand stress while remaining flexible enough to facilitate installation inside a mast.

Yes, the B&G wind transducer cable range is available in multiple lengths. This 50-metre model (000-14398-001) is designed for tall masts, although an 80-metre version also exists.

Its main function is to establish a reliable physical connection between a B&G wind sensor at the masthead and the boat's navigation system, to transmit accurate wind data to the onboard instruments.