Nosač radara Garmin GMR Fantom 5x, gornji dio

For optimal performance and safety, consider the following points when selecting the mounting location:

The radar must be mounted out of reach of people, with the vertical beam width above head height. It must be mounted high above the keel line of the vessel, with minimal obstruction of the radar beam. The mounting surface must be flat, parallel to the vessel’s waterline, and sufficiently robust to support the radar’s weight. The radar must be mounted in a location that allows for power, grounding, and network connections. Avoid mounting the radar near heat sources (exhausts, lights) or at the same height as horizontal spreaders or mast crossarms. Other electronic equipment and cables must be more than 2 meters (6.5 feet) from the radar beam path. GPS antennas must be either above or below the radar beam path. Maintain a distance of at least 1 meter (40 inches) from any transmission equipment and cables carrying radio signals (VHF). Maintain a distance of at least 2 meters (6.5 feet) from HF radios (single sideband).

For the radar pedestal installation, you will need the following tools:

A #2 Phillips screwdriverA 6 mm hex keyA drillA 15 mm (19/32 in) drill bitA 32 mm (1 1/4 in) drill bit (optional, for cable routing)A 17 mm (21/32 in) wrench and a torque wrench12 AWG (3.31 mm²) copper wire for grounding the radar housing and power converter (if applicable)Marine sealant

Yes, the radar (and the voltage converter, if applicable) must be connected to a dedicated water ground. A 3.31 mm² (12 AWG) bare copper wire (not included) is required. This wire must be routed to a dedicated water ground point and connected to the ground connector on the pedestal. After connection, the ground screw and crimp connector must be sealed with marine sealant.

The radar transmits electromagnetic energy. To avoid injury, ensure all persons are clear of the radar beam path before transmission.Do not look directly at the antenna up close while the radar is transmitting, as the eyes are the most sensitive part of the body to electromagnetic energy.Never remove the built-in fuse from the power cable. The correct fuse must be in place to prevent fire or overheating risks.Installation by a qualified marine technician is recommended for optimal performance and to avoid damaging the device or the vessel.Never open the device yourself, as it contains no user-serviceable parts and must only be opened by an authorized Garmin service technician.Use the device solely as a navigation aid.Always wear safety glasses, hearing protection, and a dust mask when drilling, cutting, or sanding.

No, it is strongly discouraged to open the GMR Fantom 5x radar pedestal yourself. The device contains no user-serviceable parts and must only be opened by a Garmin authorized service technician. Any damage resulting from opening the unit by someone other than a Garmin authorized service technician will not be covered under Garmin warranty. Additionally, the radar contains high voltages and generates non-ionizing radiation, which poses risks of serious or fatal injury.

To mount the antenna on the pedestal:

Remove the protective cover from the waveguide on top of the pedestal. Align the pedestal's waveguide with the socket under the antenna, then slide the antenna onto the pedestal. Secure the antenna to the pedestal by tightening the captive hex bolts located under the antenna arm. Tighten the hex bolts to 7.9 N·m (6 lbf·ft) torque to firmly secure the antenna without damaging it or the mounting hardware.