Prijenosni punjač EasyCharge 4,3 A

This charger is compatible with 6V and 12V lead-acid batteries (Flooded, Gel, AGM, Spiral) as well as Lithium-Ion batteries, including the Mastervolt MLS range.

The 4.3A model is optimized to fully charge batteries from 14 to 90 Ah. It can also maintain charge (winter storage) for battery banks up to 120 Ah.

Yes, the device is supplied complete. It includes a 1.8 m mains cable with Euro plug and two types of interchangeable DC connectors: a cable with eye terminals for permanent installation and a cable with crocodile clips for temporary use.

Yes. It features an ergonomic housing with an IP65 rating, making it completely dust-tight and highly resistant to water splashes. It is ideal for marine or outdoor environments.

Yes, this charger has a universal input accepting voltages from 90 to 265 V (50/60 Hz). You can therefore use it reliably anywhere in the world.

When a deeply discharged battery is connected, the charger automatically initiates the Regeneration stage. It applies a very low current to safely bring the voltage back to a normal level before proceeding to the standard charging steps.

Plug the charger into the mains without connecting it to the battery. Press the MODE button successively to scroll through the options. The selection is based on three criteria:

The voltage (6V or 12V)
The battery type (Flooded, Gel/AGM or Lithium-Ion)
The ambient temperature (above or below 10°C)

This 4.3A model includes a manual start function. Simply hold down the MODE button until the 6 indicator flashes rapidly. This wakes the battery whose internal switch has tripped and initiates charging.

No, you can charge the battery directly inside the vehicle or the boat. Just make sure to turn off the engine and all electrical consumers before plugging in the charger.

Yes, the charger is intelligent and stores the last charging mode used, even after being fully disconnected from the battery and the mains power.

The charger provides maximum safety thanks to its galvanic isolation. It is also protected against short circuits, reverse polarity, overvoltage, and overheating.

For optimal safety, first connect the positive cable (red) to the battery’s positive terminal, then the negative cable (black) to the negative terminal. Once connections are secure, you can plug the charger into the mains socket.

The control panel has LED indicators showing the charge state (25%, 50%, 75%, 100%). When the 100% LED is lit continuously, the battery is fully charged and the charger has switched to float mode.

Yes, once full charge is reached, the charger automatically switches to Float mode (trickle charging). It can remain safely connected for extended periods to keep the battery ready for use, ideal for winter storage.

The warranty covers proper operation of the device provided it is installed and used according to the manual instructions. It is limited to the cost of parts for replacement or repair of the device in case of manufacturing defect.

This 4.3 A model is recommended for batteries starting at 14 Ah. For smaller batteries (such as a 5 Ah motorcycle battery), it is preferable to use the 1.1 A model from the same range, designed for capacities from 2.2 to 25 Ah.

The 25% flashing light indicates that the charger is in Regeneration mode. This is normal behavior when it attempts to recover a battery that has undergone deep discharge.

Place the charger in a properly ventilated area. Never place it directly on the battery during charging and ensure it is not covered, as the device may heat up during normal operation.

No, it has been designed to be highly portable. It measures a compact 161 x 72 x 43.7 mm and weighs only 0.9 kg, making it easy to handle and store on a boat or in a vehicle.

No, the EasyCharge Portable range consists of standalone chargers (stand-alone) and is not compatible with Mastervolt's MasterBus communication network.