Kabeļu blīvējums CableClam 1.40"

The Blue Sea Systems CableClam 1.40" is designed for cable management and protection. It provides a watertight cable gland solution for marine installations, allowing safe penetration through decks or bulkheads while protecting the electrical system from the marine environment.

The overall dimensions of the CableClam 1.40" are as follows:

Length: 2.67 inches (67.70 mm)Width: 1.50 inches (38.16 mm)Height: 1.02 inches (25.86 mm)Base: 1.12 inches (28.33 mm)

Yes, the CableClam 1.40" is specifically designed for marine applications. Its design ensures watertightness and resistance to the elements, which are critical for recreational or commercial vessels.

The CableClam 1.40" is installed in several steps:

Drill the seal with a sharp bit of the same diameter as the cable, keeping the hole wet during drilling. The hole will be slightly smaller than the cable.Use a sharp razor knife to slit the seal from its edge to the center hole.Attach the deck ring and seal to the surface using #8 screws.Slide the compression ring onto the cable.Thread the cable through the slit in the seal.Press the seal into the compression ring.Tighten the compression ring to the deck ring by screwing each screw a few turns at a time, without over-tightening.

The CableClam 1.40" consists of the following components:

A compression ringA sealing gasketA deck ring

For securing the CableClam 1.40" deck ring to the surface, use #8 screws.

Yes, it is necessary to drill the seal. You must drill a hole with a drill bit the same size as the cable, ensuring the hole is slightly smaller than the cable. Then, use a razor blade to slit the seal from its edge to the central hole to insert the cable.