Ciparu komutators līdzstrāvai 10x10 A

The Mastervolt 10x10A digital DC switch is a decentralized input/output module designed for MasterBus networks. It allows control of up to ten DC channels, such as lighting, pumps, or onboard electronics, with a 10 A capacity per channel.

No, this product is now obsolete. It is offered here as a spare part for maintenance and repair of existing marine electrical installations, which avoids having to rewire the entire vessel.

This module operates within a voltage range of 8 to 30 V. It is therefore natively compatible with 12 V and 24 V battery banks.

Each individual output can handle 10 A. However, multiple outputs can be wired in parallel to support higher currents, up to a total maximum of 100 A for the entire module.

Electrical safety is ensured by dual protection on each channel: a configurable software fuse rated at 10 A and a conventional hardware fuse rated at 15 A.

In case of network failure, a manual hardware reset (bypass) is possible directly on the device. The 15 A hardware fuses have positions allowing manual forcing of channel power on or off.

Yes, the module includes ten built-in dimmers. This allows you to program the dimming of onboard lights directly from the system, without needing to add external dimmers.

Also called the "follow-me-home" function, this is an automation that keeps the lights on for a short time after the switch is turned off, giving you time to leave the area safely.

For input connections, the module accepts cables up to 95 mm². For output connections, the maximum cable cross-section is 4 mm².

The switch has an IP21 rating. It is not waterproof and must be installed in a dry location, protected from rain, humidity, and condensation.

The module measures 40 x 229 x 110 mm (Height x Width x Depth) and weighs 0.75 kg. Its compact format makes it easy to integrate into the boat's electrical panels.

No, its power consumption on the DC side is extremely low. It is less than 2 mA when powered at 12 V or 24 V.

The device features a communication LED on the front panel. If it is lit continuously, the operation is normal. Different blinking patterns indicate power presence, an active alarm, or manual forcing of an output.

Yes, control and configuration are done via the MasterBus network. You will need a compatible display, such as the MasterView Easy, or the MasterAdjust software on a PC connected via a USB interface.

Yes, it is entirely possible to connect a standard On/Off switch directly to the switch to generate an electrical signal and control an output, without necessarily needing to go through a digital display.

When a software fuse trips due to an overload, it can be easily reset remotely via the MasterBus display interface without needing physical access to the module.

Yes, the module integrates smart alarm functions. It notably emits an alarm signal on the MasterBus network in case of overload detected on one of its channels.

Yes, the power input connections can be directly wired to a MasterShunt or to a Mastervolt DC Distribution system for optimal wiring management.

By using the hardware bypass, the input is directly connected to the output via the 15 A fuse. Caution: this bypasses software settings such as the dimmer. Additionally, raw input voltage will be applied to the connected device, which requires careful attention if you have 12 V devices on a 24 V network.