Dławik CableClam 1.40\"

The Blue Sea Systems CableClam 1.40" is designed for cable management and protection. It provides a watertight cable pass-through solution for marine installations, enabling safe penetration of decks or bulkheads while protecting the electrical system from the marine environment.

The overall dimensions of the CableClam 1.40" are as follows:

Length: 2.67 inches (67.70 mm)Width: 1.50 inches (38.16 mm)Height: 1.02 inches (25.86 mm)Base: 1.12 inches (28.33 mm)

Yes, the CableClam 1.40" is specifically designed for marine applications. Its design ensures watertightness and resistance to elements critical for recreational or commercial vessels.

Installing the CableClam 1.40" takes several steps:

Drill the seal with a sharp bit the same diameter as the cable, keeping the hole wet during drilling. The hole will be slightly smaller than the cable.Use a sharp razor knife to split the seal from its edge to the center hole.Attach the deck ring and seal to the surface with #8 screws.Slide the compression ring onto the cable.Insert the cable through the seal’s slit.Press the seal into the compression ring.Screw the compression ring to the deck ring, tightening each screw a few turns at a time without over-tightening.

The CableClam 1.40" consists of the following components:

A compression ringA sealing gasketA deck ring

For mounting the CableClam 1.40" deck ring to the surface, it is recommended to use #8 size screws.

Yes, the seal must be drilled. You need to drill a hole with a drill bit the same size as the cable, ensuring the hole is slightly smaller than the cable. Then, use a razor blade to split the seal from its edge to the central hole to insert the cable.