Płytka Contura szczelna 12 V DC – sterowanie pompą zęzową

This control panel is designed to provide consolidated management and circuit protection for a single bilge pump. It allows the pump to be controlled efficiently and safely.

Yes, the front panel is rated IP66 when mounted with the included gasket. This means it is protected against powerful water jets and can withstand common marine exposures such as salt spray, rain, hose-downs, and brief immersions.

The panel is constructed from 5052-H32 aluminum alloy with a thickness of 0.100 inches. Its finish is a two-part textured polyurethane in graphite color.

This panel is designed to operate with 12V or 24V DC systems.

The panel integrates a Contura switch of type (ON)-OFF-ON. It features an LED indicating the circuit's operating state, with an estimated lifespan of 100,000 hours (at half-life).

The fuse holder accepts commonly available 1-1/4” x 1/4” glass fuses, whether they are AGC (fast-acting) or MDL (slow-blow) types.

Yes, a 15 amp AGC (fast-acting) fuse is pre-installed in the fuse holder of the panel.

The switch and fuse holder are designed for a maximum current of 20 amperes for a 12V system and 15 amperes for a 24V system.

The 8263-BSS panel is specifically designed for monitoring and protecting the circuit of a single bilge pump.

No, this panel is not spark-proof. It must not be installed in explosive environments, such as gasoline engine compartments or battery compartments, as the switches are not spark-resistant.

Before starting the installation, it is imperative to disconnect the main positive cable from all batteries to eliminate any risk of a short circuit. You must also unplug the AC shore power cord to prevent any risk of electrocution.

Yes, it is important to choose a mounting location that is not an area where flammable vapors (from propane, gasoline, or lead-acid batteries) could accumulate. Since the panel is not spark-proof, it could ignite these vapors.

A gasket is included with the panel. It must be placed between the panel and the mounting surface. Ensure all surfaces are clean and free of debris, then tighten the panel mounting screws to ensure a proper seal.

The positive power wire (red) must be sized for a 3% voltage drop at the panel’s rated capacity or the maximum current to be carried, whichever is lower. It is recommended to size this wire for the panel’s full capacity, which will typically require at least a 10 AWG wire for a typical 10-foot run between the panel and batteries in a 12V system.

After installing the panel, reconnect the main positive cable to the battery terminals and turn on the main switch to power the panel. Turn on the bilge pump and check the voltage at the panel. Compare this voltage to the battery terminal voltage to ensure voltage drop is less than 3%.

Yes, the panel is compatible with most bilge pumps, provided their current draw does not exceed the panel’s maximum ratings: 20 amps for a 12V system or 15 amps for a 24V system. It is critical to use the fuse recommended by the bilge pump manufacturer, with a maximum rating of 20 amps.