ECLIPSE DL55, plafonnier biały, wykończenie białe

This Garmin ECLIPSE DL55 downlight provides white lighting with a 5000 K color temperature.

The ECLIPSE DL55 downlight is equipped with two 3W white LEDs. The typical nominal power is approximately 4 watts per light.

Yes, the ECLIPSE DL55 downlight is fully sealed and designed for installation both indoors and outdoors, including in the vessel's wet areas. It has an IP68 protection rating.

The typical electrical consumption of this downlight is 0.33 amperes at 12 volts, with a nominal power output of approximately 4 watts per light.

No, although the ECLIPSE DL55 downlight can be installed in wet areas and is fully sealed with an IP68 rating, it is not designed for permanent submersion in water.

This ECLIPSE DL55 downlight is designed to provide an ultra-wide beam angle, ensuring effective general lighting.

For indoor installations, use the supplied spring clips. Gently pull the clips backward and insert the downlight into the hole, releasing the clips once the light is in position.

For outdoor installations or in damp areas, it is recommended to secure the downlight using suitable marine sealant or adhesive. Remove the spring clips and the black gasket from the fixture, then apply a small amount of adhesive around the glass bezel. Push the downlight into place while rotating slightly to evenly distribute the adhesive. Clean any excess adhesive with a soft cloth, soap, and water, without using chemical cleaners.

The minimum required depth for mechanical installation of the ECLIPSE DL55 downlight is 30 mm (1.18 in).

Yes, a qualified professional should always perform the electrical and mechanical installation of the ECLIPSE DL55 downlight.

Yes, the rear of the downlight can become hot to the touch during operation. The mounting surface must be suitable for this type of luminaire.

Before any installation, always ensure the vessel's power source and battery are disconnected or isolated. It is also recommended that a qualified professional carries out the electrical and mechanical installation.

The ECLIPSE DL55 downlight is designed to operate exclusively on boats equipped with a 12V system. It can operate within a direct current (DC) voltage range of 10 to 15 volts. Do not connect voltages outside this range or directly to an alternating current (AC) supply.

No, the ECLIPSE DL55 downlight is designed to be used only with a simple on/off switch or with the ECLIPSE control center (sold separately). It must not be connected to other third-party lighting control products or dimmers.

For single-color lights like this white model, you can toggle the power switch to adjust the brightness, then toggle again to pause. Turn off the light for 2 seconds to reset it to full power.

Yes, the ECLIPSE DL55 downlight is compatible with the ECLIPSE control unit, which is sold separately. Using the control unit provides access to extended features and dynamic effects for compatible models.

LUMISHORE Ltd, the manufacturer, guarantees its lighting systems, including downlights, against manufacturing defects for a period of three years from the original date of purchase.

The warranty may be voided in case of misuse, negligence, incorrect installation, damage caused by disasters (fire, flood, lightning), installation by unqualified personnel, unauthorized repair or modification, or non-compliance with all installation, maintenance, and usage directives specified in the document.

No, the ECLIPSE DL55 downlight must be mounted on a flat surface. It is not designed to be installed on curved surfaces.

Yes, the ECLIPSE DL55 can be integrated into a simple installation with a switch, or into a more complete system with ECLIPSE control if the rest of the system is designed for it.