SUPRA THX1604 EOS, projektor wodoszczelny i sterownik

The Garmin Lumishore EOS THX1604 is a high-intensity underwater through-hull projector. It is designed for recreational boaters and yacht owners seeking a discreet and high-performance lighting solution with a flush-mounted aesthetic on the hull.

The THX1604 EOS floodlight delivers 17,500 lumens in RGB (full spectrum) version. It provides an ultra-wide beam angle of 110°, creating an extended halo effect underwater.

The THX1604 EOS underwater light is available in full-spectrum RGB (RGBW) version, offering flexibility to create various underwater lighting ambiances.

The THX1604 EOS spotlight features a 110° ultra-wide beam angle, allowing it to cast light over an extended area and create a halo effect.

The THX1604 EOS spotlight is designed for durability in marine environments. It features a marine-grade bronze body and a borosilicate glass lens.

Yes, the THX1604 EOS spotlight has an IP68 protection rating. This ensures full resistance to dust and prolonged immersion in water.

The Garmin SUPRA THX1604 EOS underwater light is a through-hull model. It is designed for flush-mounted installation, providing a clean aesthetic on the boat's hull.

The spotlight can be installed on GRP hulls (glass-reinforced plastic or fiberglass). For wooden, metal, or carbon fiber hulls, an insulation kit will be required.

For optimal performance, the floodlight must be installed between 150 and 250 mm (6 to 10 inches) below the boat’s minimum waterline.

For optimal lighting results, it is recommended to install the floodlights at a distance between 0.8 metres (2.5 feet) and 2 metres (6.5 feet) from each other.

Several precautions are essential:

Always ensure the vessel's power source and battery are disconnected or isolated before installation. Electrical and mechanical installation must be performed by a qualified professional. Use an appropriate fuse or circuit breaker to protect the entire system. Never attempt to install or remove the spotlight while the boat is in the water. The spotlight must not be exposed to temperatures above 65°C (150°F), such as near hot engine components or exhaust emissions.

The spotlight must be mounted on a flat (non-curved) surface of the hull. Installation is only possible on the transom or the sides of the hull.

The tightening torque of 3 Nm (26 in-lbs) per bolt must not be exceeded for the mounting bolts of the spotlight.

All Lumishore products must be connected to the DC system via a bonding strap for galvanic protection. However, this requirement does not apply to lights that are fully submerged at both the front and rear, which is typically the case for a through-hull light.

The THX1604 EOS spotlight is compatible with Lumishore EOS control systems, such as the EOS-LUX control center, the STV 2204-i, or a compatible multifunction display (MFD).

The THX1604 EOS spotlight requires a 24V DC power supply. It is not rated for 12V DC use.

The THX1604 EOS spotlight draws a maximum current of 6.5 A when powered by 24V DC.

Yes, a DMX cable is required for the connection. A 1-meter DMX cable is included, and extension cables are available if a longer length is needed. A DMX terminator (PN: 24-0087) must also be installed.

Yes, it is essential to use a fuse or circuit breaker appropriate for protecting the entire lighting system.

Incorrect installation of the THX1604 EOS light will void the product warranty. It is therefore critical to strictly follow the provided installation instructions.