LUX SL180, pasek LED, CRGBW, 1100 mm

The Garmin LUX SL180 LED strip provides CRGBW full-spectrum lighting, including cool white, red, green, blue, and warm white. The white light is adjustable from 2700K to 6500K.

The Garmin LUX SL180 light strip has a length of 1100 mm.

Yes, the LUX SL180 strip is fully encapsulated and has IP68 protection. This means it is protected against dust and temporary immersion, making it suitable for marine environments and wet areas. However, it is not designed for permanent submersion.

The Garmin LUX SL180 light strip integrates 180 LEDs per meter, providing powerful and uniform lighting.

The LUX SL180 light strip has a nominal power of 5 watts per meter.

The Garmin LUX SL180 LED strip requires an input voltage range of 23 to 25V. It must be used exclusively with Lumishore LUX Strip Light Driver control modules.

Yes, the LUX SL180 LED light bar is made from UV-resistant material. However, it is recommended not to install it in areas exposed to direct strong sunlight.

The LUX SL180 LED strip is specifically designed to work with Lumishore LUX Strip Light Driver control modules. It integrates seamlessly with existing Garmin or Lumishore systems.

Yes, you can control the LUX SL180 via a compatible multifunction display (MFD), a dedicated Lumishore screen, a smart device, or a momentary switch, provided it is connected to a Lumishore LUX Strip Light Driver module.

No, the LUX SL180 strip is designed to be used only with Lumishore LUX Strip Light Driver control modules. Using third-party lighting products or controllers is not recommended and may void the warranty.

The LUX SL180 strip has a minimum bending radius of 50 mm on the vertical axis only. It is critical not to bend it on the horizontal axis or twist it.

Before applying the LED strip with the 3M adhesive, it is essential to thoroughly clean the mounting surface using isopropyl alcohol (IPA) and ensure it is free of dust and dirt.

Yes, for outdoor installation in damp areas or with tight bend radii, it is recommended to use mechanical fastenings (mounting clips) in addition to the adhesive layer. These fastenings should be spaced 25 to 30 cm apart or placed on each side of a bend.

During handling, it is important to follow these precautions:

Unroll the tape carefully from the reel to prevent it from falling or twisting. Do not apply pressure to the LED area, only to the edges of the tape. Do not pull, stretch, twist, or bend the tape on the horizontal axis. For lengths over one meter, it is recommended to use two people.

It is recommended to let the 3M adhesive cure for 24 hours before turning on the LED strip to ensure optimal adhesion.

Yes, it is imperative to always ensure that the ship's power source and battery are disconnected or isolated before proceeding with the installation.

Lumishore Ltd guarantees its lighting systems, including the LUX SL180 light strip and its accessories, against manufacturing defects for a period of three years from the original purchase date.

The warranty may be voided in several situations, including:

Abusive use or incorrect installation.Negligence or damage caused by disasters (fire, flood, lightning, etc.).Installation by unqualified personnel or unauthorized repairs/modifications.Failure to comply with the installation, maintenance, and use guidelines specified in the documentation.Using third-party control modules not approved (other than Lumishore LUX Strip Light Driver) also voids the warranty.

If your lighting system encounters an issue during the warranty period, contact your dealer, the boat manufacturer, or your broker as soon as you detect the defect.