LUX SL180, pasek LED, CRGBW, 2600 mm

The Garmin LUX SL180 light bar features CRGBW lighting, meaning it can produce vibrant colors (red, green, blue) as well as adjustable white light (cool and warm). This allows for rich, customizable lighting for various onboard ambiances.

The Garmin LUX SL180 light strip has a length of 2600 mm.

Yes, the LUX SL180 LED light strip is fully sealed at the factory and certified to IP68. This certification ensures high resistance to dust and water, making the product suitable for indoor and outdoor installations above the waterline. It is not designed for permanent submersion in water.

The LUX SL180 LED strip is made from UV-resistant materials and has passed salt spray testing, ensuring durability in demanding marine environments.

The LUX SL180 LED strip integrates 180 CRGBW LEDs per meter, enabling rich and customizable lighting output.

The power consumption of the LUX SL180 LED light strip is 5 watts per meter.

No, the LUX SL180 light strip is supplied in pre-cut and factory-sealed lengths to meet IP68 standards. Cutting it is strictly prohibited, as this would void the warranty and compromise its waterproofing.

For installation, clean the mounting surface thoroughly with IPA (isopropyl alcohol) to ensure it is free of dust and dirt. Then remove the 3M adhesive backing and press the strip firmly into place, applying pressure only to the edges. Allow the adhesive to cure for 24 hours before powering on the light.

For outdoor installations, wet areas, or tight bends, it is recommended to use mechanical fasteners in addition to the adhesive layer. Fastening clips can be placed every 25 to 30 cm and/or on each side of a bend for better security.

Yes, the LUX SL180 light strip has a minimum bending radius of 50 mm on the vertical axis. It is important not to bend it on the horizontal axis or twist it, as this could damage it.

The LED light strip must not be installed in areas exposed to direct sunlight for extended periods, as it is made from UV-resistant materials but is not designed for constant and intense exposure. It must also not be permanently submerged in water.

Yes, it is important not to let the strip fall or twist. Carefully unroll it from the reel. Do not apply pressure on the LED area; press only on the edges of the strip. Do not pull, stretch, twist, or bend the strip on the horizontal axis. For lengths over 1 meter, it is recommended to use two people for installation.

The LUX SL180 light strip must be connected exclusively to the Lumishore LUX Strip Light Driver module. It is not compatible with other third-party lighting control products or drivers.

The Lumishore LUX Strip Light Driver module, required for the strip to operate, works within an input voltage range of 10.5 to 31 VDC. The LED strip itself is powered by the driver with an output voltage of 23 to 25V.

No, the LUX SL180 LED strip must be connected to the Lumishore LUX Strip Light Driver module. A direct connection or connection to a third-party driver will void the warranty and may damage the product.

No, the LUX SL180 LED strip is designed to be used exclusively with Lumishore LUX Strip Light Driver modules. Use with third-party lighting control products or drivers is not supported and will void the warranty.

Lumishore Ltd guarantees its lighting systems, including the LUX SL180 light strip, against manufacturing defects for a period of three years from the original purchase date.

The warranty may be voided in case of misuse, abuse, incorrect installation, negligence, unauthorized repair or modification, installation by unqualified personnel, or failure to comply with the installation, maintenance, and usage instructions specified in the manual. Using third-party drivers also voids the warranty.

If you encounter a problem with your lighting system during the warranty period, you must contact your dealer, the boat manufacturer, or your broker as soon as you notice the defect.