LUX SL180, pasek LED, CRGBW, 4400 mm

The Garmin LUX SL180 LED light strip features a CRGBW color spectrum, including cool white, red, green, blue, and warm white. It also allows tunable white from 2700K to 6500K.

The Garmin LUX SL180 LED light strip has a total length of 4400 mm (4.4 meters).

Yes, the LUX SL180 LED light strip is rated IP68, meaning it is dustproof and can withstand temporary immersion. However, it is not designed for permanent submersion in water.

The Garmin LUX SL180 LED strip is made from UV-resistant materials and has been tested in salt spray to ensure durability in marine environments.

The LUX SL180 LED light strip integrates 180 CRGBW LEDs per meter, ensuring uniform and intense lighting output.

The power consumption of the LUX SL180 LED strip light is 5 watts per meter. For the 4400 mm model, the total consumption is 22 watts.

No, the LUX SL180 light strip is supplied in ready-to-use lengths and factory-sealed to meet IP68 standards. It must never be cut.

The LED strip is made from UV-resistant materials, but it must not be installed in areas exposed to direct strong sunlight. It can be installed indoors or outdoors, including in damp areas, but not in permanent submersion.

For installation with 3M adhesive, clean the mounting surface thoroughly with IPA to remove dust and dirt. Peel off the 3M adhesive backing and press the light strip firmly, applying pressure only to the edges and not the LEDs. Allow the adhesive to cure for 24 hours before powering on the strip.

For outdoor installations, wet areas, or tight bends, it is recommended to use mechanical fasteners in addition to the adhesive layer. These fasteners should be placed every 25 to 30 cm or on each side of a bend.

The LED strip has a minimum bending radius of 50 mm on the vertical axis only. It must not be bent on the horizontal axis or twisted.

Yes, it is imperative to always ensure that the boat's power source and battery are disconnected or isolated before proceeding with the installation.

Electrical and mechanical installation must be carried out by a qualified professional.

Yes, Lumishore can supply stainless steel clips for narrow mounting channels. These clips are secured using a countersunk screw. They must be gently opened to insert the strip, then tightened around the strip once in place.

When installing LED strips longer than one meter, it is recommended to use two people: one for installation and the other to hold and unroll the strip. Unroll the strip carefully, avoiding drops or twists, and lay it flat in a straight line to prevent creases or twists. Do not apply pressure on the LEDs, only on the edges of the strip.

The Garmin LUX SL180 LED strip must be connected exclusively to Lumishore LUX light strip control modules. It must not be connected to other third-party products or lighting control drivers.

The LUX SL180 LED strip requires an input voltage of 23 to 25V. It must only be used with Lumishore LED strip driver modules.

Yes, the LED ribbon control can be operated via compatible multifunction displays (MFD) once connected to the Lumishore LUX pilot module.

Lumishore Ltd guarantees its lighting systems, including LED strips and associated accessories, against manufacturing defects for a period of three years from the original date of purchase.

The warranty may be void in case of misuse, abuse, incorrect installation, negligence, damage caused by disasters (fire, flood, lightning), installation by unqualified personnel, unauthorized repair or modification, or installations not approved by the manufacturer. Failure to comply with installation, maintenance, and usage guidelines also voids the warranty, including use with unauthorized third-party autopilots.